How much coolant does a Ford Edge hold?
The Ford Edge typically holds about 9.5 to 12 quarts (roughly 9 to 11.5 liters) of coolant in its cooling system, depending on the engine and model year.
Overview of coolant capacity by engine
The Edge used two common engine configurations over its production run. The smaller EcoBoost 2.0-liter variants tend to require less coolant than the larger V6 engines. The figures below reflect typical totals for the full cooling circuit, including the radiator, engine block, hoses, heater core, and reservoir. Exact capacity can vary by trim, drivetrain, and year.
- 2.0L EcoBoost (late-model Edge): approximately 9.5 quarts (9.0 L).
- 3.5L V6 (earlier Edge and common across many trims): approximately 12 quarts (11.4 L).
Note that some AWD configurations, hybrids, or manufacturing revisions can adjust the total. For the precise figure for your vehicle, consult the owner's manual or Ford’s official service data.
How to check and refill coolant safely
When topping up or replacing coolant, use the correct type and follow proper safety steps. The following guide outlines a typical process, but always refer to your specific model’s manual for exact instructions.
- Ensure the engine is completely cool before opening the radiator cap or expansion reservoir cap.
- Locate the coolant reservoir and check the level against the “MIN” and “MAX” marks when the engine is cold.
- Use the correct coolant type recommended by Ford (typically a Motorcraft OE coolant or an equivalent meeting Ford specifications) and mix with distilled water if a premixed is not already provided. Do not mix with incompatible coolants.
- If the level is low, slowly add coolant until it reaches the appropriate level on the reservoir. Do not overfill.
- If you suspect air pockets after refilling, start the engine with the radiator cap off only when safe and the engine is cooling; run until the thermostat opens and the level stabilizes, then re-cap and recheck after the engine cools.
- Inspect for leaks around hoses, the radiator, and the reservoir. If you notice a leak or overheating persists, seek professional service.
- Dispose of old or spilled coolant properly and clean up any spills to prevent environmental harm or slipping hazards.
Following these steps helps maintain proper engine temperature and prevents overheating. If you’re unsure about the process, a professional mechanic can perform a coolant flush or top-up quickly and safely.
Summary
In summary, the Ford Edge’s coolant capacity varies by engine: about 9.5 quarts for the 2.0L EcoBoost and about 12 quarts for the 3.5L V6. Always confirm the exact capacity for your specific model year and configuration in the owner's manual or Ford’s official service data. Regularly check coolant levels and use the correct OEM-recommended coolant to keep the cooling system functioning properly.
How many gallons of coolant do I need?
Let's consider an example: If the cooling system capacity of a vehicle is 12 gallons and the manufacturer recommends a 50/50 mix, you would need 6 gallons of antifreeze to fill the radiator. In this case, you would mix 3 gallons of antifreeze with 3 gallons of distilled water.
How much coolant does a Ford Edge take?
Capacities and Specifications - 3.5L
| Item | Capacity |
|---|---|
| Engine oil | 6.0 qt (5.7 L) |
| Engine coolant | 11.7 qt (11.1 L) |
| Brake fluid | Between MIN/MAX on brake fluid reservoir |
| Rear differential (All Wheel Drive) fluid | 2.4 pt (1.15L) |
What kind of coolant does a 2011 Ford Edge take?
Motorcraft 33YT71W Coolant Antifreeze Fits 2011-2022 Ford Edge.
How many gallons does a Ford Edge hold?
18.5 gallons
What is the Gas Tank Size of the Ford Edge? The 2022 Ford Edge uses a fuel tank capacity of 18.5 gallons, resulting in a long drive anytime drivers gas up their tank. In an SUV it is rare to feel a sporty drive but the 2022 Edge features it with ease.
