Loading

How much oil does a 1.4 Chevy Cruze take?

The 1.4-liter turbocharged engine in the Chevy Cruze requires 4.5 quarts (4.25 liters) of oil for a standard oil change. This includes the oil filter, which holds an additional 0.5 quarts (0.47 liters) of oil.


Detailed Answer


The Chevy Cruze is a popular compact car that has been in production since 2008. The 1.4-liter turbocharged engine is one of the most common powertrains found in the Cruze, known for its balance of fuel efficiency and performance.


When it comes to oil changes for this engine, the recommended oil capacity is 4.5 quarts (4.25 liters). This includes the oil filter, which holds an additional 0.5 quarts (0.47 liters) of oil. So, the total amount of oil needed for a complete oil change on a 1.4 Chevy Cruze is 4.5 quarts (4.25 liters).


It's important to use the correct oil type and viscosity recommended by Chevrolet for the Cruze. The manufacturer typically specifies 0W-20 or 5W-30 synthetic motor oil for optimal engine performance and protection.


Oil Change Procedure



  • Park the Cruze on a level surface and apply the parking brake.

  • Locate the oil drain plug, usually on the bottom of the oil pan, and place a drain pan underneath.

  • Unscrew the drain plug and allow the old oil to fully drain out.

  • Once drained, replace the drain plug and tighten it securely.

  • Locate the oil filter, typically accessible from the top of the engine, and use an oil filter wrench to remove it.

  • Apply a thin coat of new oil to the gasket of the new oil filter, then screw it on by hand until secure.

  • Unscrew the oil fill cap and pour in 4.5 quarts (4.25 liters) of the recommended oil.

  • Replace the oil fill cap and start the engine, checking for any leaks.

  • Allow the engine to run for a few minutes, then check the oil level using the dipstick.

  • Top up the oil if necessary to bring the level to the full mark on the dipstick.


Following the proper oil change procedure and using the correct oil quantity and type is essential for maintaining the health and longevity of the 1.4-liter turbocharged engine in the Chevy Cruze.

How many miles per gallon does a 2014 Chevy Cruze 1.4 L Turbo get?


Fuel & MPG

Fuel typeRegular unleaded
EPA city/highway MPG26/38 MPG
EPA combined MPG30 MPG



What kind of oil does a 2012 Chevy Cruze 1.4 take?


The recommended Chevy Cruze oil type is 5W-30, while 0W-30 is also useful in very cold climates where freezing temperatures are the norm.



Can I put 10w30 instead of 5w30?


Using 10W-30 instead of 5W-30, however, could make cold starts more difficult. It's helpful to think of the “W” as standing for “winter.” The lower the oil's “W” viscosity, the more readily it will flow when cold. In this case, 5W-30 will flow more easily at startup than 10W-30.



How much oil does Cruze take?


The spec for your 1.4 engine is 4.23 quarts from the factory, now that is with a completely dry engine.



How much oil goes in a 1.4 L Chevy Cruze?


4.2 quarts
Capacity: 4.2 quarts (with filter). After refill check oil level.



What oil does a 1.4 petrol take?


Mobil 1 ESP 5W30 Fully Synthetic Engine Oil 1 Litre.



What happens when you overfill oil?


Engine damage – Too much lubricant in the system can cause pressure on the crankshaft to increase. This can result in oil entering the crankshaft exhaust pipe, running through into the combustion chamber, blocking the suction hose with oil soot and potentially leading to engine overload.



What is the life expectancy of a Chevy Cruze 1.4 turbo?


The Chevy Cruze vehicle can last up to 250,000 miles with proper maintenance, with an expected annual drive of around 15,000 miles. However, Cruze car owners' opinions on longevity are divided, with 19% believing their vehicles will reach 200,000 miles, whereas 33% disagree.



What kind of oil does a 2014 Chevy Cruze 1.4 L Turbo take?


SAE 5W-30 full synthetic motor oil
What Type of Oil Does a 2014 Chevy Cruze Take? Chevrolet recommends using SAE 5W-30 full synthetic motor oil for the 2014 Chevy Cruze, which can store 4.0 L or 4.2 quarts of engine oil.



How much oil does a Chev Utility 1.4 take?


3.5 litres
It is common for Chevy dealers to increase the amount of time they charge for the service, they will charge you for 1.3 hours of labour. A Chevrolet utility bakkie takes 3.5 litres of oil.


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.