How much oil does a 1.5 Ford Transit Connect take?
Typically about 4.0 liters of engine oil are required for an oil change on most 1.5 EcoBlue Transit Connect engines, including the oil filter. Exact capacity can vary by model year and market, so verify the specification in your owner’s manual or with a Ford dealer.
This article examines the expected oil capacity for the 1.5-liter Transit Connect engine, notes how capacity can vary by variant and year, and covers the recommended oil type and maintenance basics to help you perform accurate top-ups and changes.
Engine variants and capacity
Note on engine variants: Ford has offered the 1.5 EcoBlue diesel in Transit Connect across multiple markets and model years. Capacity figures can vary slightly depending on the exact engine variant, year, and the type of oil filter used during a change.
- Typical total oil capacity (engine oil + filter): about 4.0 L (approximately 4.2 quarts). Depending on the exact engine variant and the oil filter type, capacities can range from roughly 3.8 L to 4.3 L.
For a precise figure, consult your vehicle’s manual or Ford service data for your specific year and market.
Oil type and service intervals
Recommended oil grade
Most recent Ford EcoBlue 1.5 diesel engines in Transit Connect models are recommended to use a fully synthetic 5W-30 oil that meets Ford specifications. Always check the exact specification listed in your owner's manual or on the Ford service data for your vehicle’s year and market.
Oil change interval
Oil-change intervals vary by market and usage conditions, but a common guideline for EcoBlue diesels is around every 12,000 miles (20,000 km) or once a year, whichever comes first. Severe conditions may require more frequent changes; follow Ford’s recommendations for your vehicle.
How to check and top up oil
To ensure you maintain the correct oil level after an oil change or topping up, follow these steps.
- Park on level ground, turn off the engine, and wait 5–10 minutes for oil to settle.
- Open the hood and locate the engine oil dipstick and filler cap.
- Check the oil level on the dipstick. It should be between the MIN and MAX marks; if low, add oil in small increments.
- Use the oil grade specified in the manual and avoid mixing different oils.
- After topping up, run the engine for about a minute, then recheck the level and ensure it is within range.
- Dispose of used oil properly and reset any service indicators if applicable.
Regularly monitor the oil level, especially after a top-up or in extreme operating conditions. Never exceed the MAX line to avoid overfill.
Summary
The 1.5 L EcoBlue Ford Transit Connect typically requires about 4.0 liters of engine oil for an oil change, including the filter, though exact capacity can vary by year and market. Always confirm the precise figure and oil spec in your owner’s manual or with a Ford dealer, and use a fully synthetic 5W-30 oil that meets the recommended Ford specification. Stay compliant with the recommended service intervals and check the oil level regularly to avoid underfill or overfill.
