How much oil does a 2002 Ford Excursion take?
The typical oil capacity for a 2002 Ford Excursion is about 6 quarts (roughly 5.7 liters) when performing an oil change with a new filter.
The Excursion from that year offered two common engines—the 5.4-liter V8 and the 6.8-liter V10—and both typically require about the same amount of oil for a standard change with a fresh filter. Exact amounts can vary slightly depending on the engine variant and whether you replace the filter. Always verify with the owner's manual and check the dipstick after filling.
Engine options and official capacity
Official listings and repair references generally list a 6-quart capacity for both main engines when performing a standard oil change with a filter.
- 5.4L V8: 6 quarts (with filter)
- 6.8L V10: 6 quarts (with filter)
In practice, most owners fill to about 6 quarts and then check the level with the dipstick, topping off as needed to reach the full mark.
How to check and fill the oil
Before you begin, know these steps to ensure the oil level is correct and the engine is not overfilled.
- Run the engine briefly, then park on level ground and turn it off. Wait several minutes for the oil to settle.
- Open the hood and locate the oil dipstick, then pull it out.
- Wipe the dipstick clean, reinsert fully, then pull it out again to check the level.
- If the level is below the full mark, add oil gradually in small increments (about 1/2 quart at a time) and recheck with the dipstick.
- Do not overfill; overfilled oil can cause engine problems. Stop when the dipstick reads at or near the full line.
- Replace the dipstick and cap; start the engine and let it run briefly, then recheck after a few minutes of idle to confirm the level.
Following these steps will help ensure the engine has the correct oil amount after an oil change.
Summary
The 2002 Ford Excursion generally takes about 6 quarts (roughly 5.7 liters) of engine oil when performing a standard oil change with a new filter, for both the 5.4L V8 and the 6.8L V10 engines. Always verify with the owner’s manual and confirm the fill level with the dipstick after adding oil.
How many quarts of oil for a 6.8 V10?
The Ford 6.8L V10 oil capacity is typically 6 quarts (5.7 L) with a filter change, though some sources cite 7 quarts (6.6 L), so it's best to check your owner's manual and use the dipstick to confirm the correct level after refilling. Some specific applications, like certain 2019 models, may require 7 quarts.
- Standard capacity: The most common capacity is 6 quarts (5.7 L) when changing the oil and filter.
- Varying capacity: Some Ford sources and owners report a 7-quart (6.6 L) capacity, especially for newer models or specific applications.
- Recommendation: Always refer to your specific vehicle's owner's manual for the most accurate information.
- Final check: After adding oil, start the engine, let it run for a minute, turn it off, and then check the dipstick to ensure the level is correct and top off as needed.
How many quarts of oil does a 6.0 L V8 take?
15 quarts
Standard Oil Capacity Specifications
The 6.0L Powerstroke engine holds approximately 15 quarts of oil when completely drained, including the oil filter replacement.
How many quarts of oil does a 2002 Ford Excursion take?
6 quarts
Engine Oil
Capacity: 6 quarts (with filter).
What oil does a 2002 Ford Excursion V10 take?
The recommended oil for a 2002 Ford Excursion with a 6.8L V10 engine is 5W-20, and the capacity is 6 quarts with a filter change. Some owners suggest 5W-30 for high-mileage or heavily-used engines, while others prefer 5W-30, but 5W-20 is the manufacturer's specified viscosity.
Oil type and specifications
- Viscosity: 5W-20
- Capacity: 6 quarts (with filter)
- Type: Full synthetic or a blend is acceptable, with 5W-20 being the preferred viscosity from Ford, even if an older manual or oil cap suggests 5W-30.
- Filter: Always use a high-quality oil filter, such as the Motorcraft FL-820s, as cheap filters can cause valve train issues.
Important considerations
- Check your manual: Always check the owner's manual for the most accurate and specific recommendations for your vehicle.
- Engine wear: For engines with very high mileage or those that are worn, a thicker oil like 5W-30 might be a consideration, but 5W-20 is still the manufacturer-recommended choice.
- Climate: Oil viscosity can be affected by climate. For extremely hot climates, thicker oil may be preferable, but stick to the manufacturer's recommendation for a 6.8L V10 engine.
