How much oil does a 2010 Acura ZDX take?
The 2010 Acura ZDX with the 3.7-liter V6 uses about 5.5 quarts (5.2 liters) of engine oil when performing a full oil change with a new filter. Always confirm the exact amount with your owner's manual or the under-hood oil sticker.
Oil capacity for the 3.7L V6 in the ZDX
The ZDX’s 3.7-liter V6 is configured for a full oil change including a new filter. The official capacity is 5.5 quarts (5.2 liters). This figure is the standard reference for a complete change; actual draw may vary slightly depending on service details.
Key capacity figure for reference:
- Engine oil capacity with a full filter change: 5.5 quarts (5.2 L)
Note: The amount can vary slightly if you do not replace the filter or use different draining procedures. After adding oil, always verify the level with the dipstick and top up as needed.
How to perform an oil change on the 2010 ZDX
Below is a practical, step-by-step guide to help you complete an oil change and reach the correct fill level.
- Warm the engine briefly, then shut it off and park on level ground.
- Place a drain pan beneath the oil pan, remove the drain plug, and let the old oil drain completely.
- Remove the old oil filter and dispose of it properly.
- Install a new oil filter compatible with the 3.7L V6 and lubricate the seal.
- Reinstall the drain plug, then add the recommended amount of fresh oil (5.5 quarts with a new filter).
- Check the oil level with the dipstick and top up until the level sits between the minimum and maximum marks.
Carrying out these steps carefully helps ensure proper lubrication and accurate oil level readings after the change.
Additional considerations
Always refer to the owner's manual for the exact oil grade and any model-year nuances. If you’re unsure about the correct specification or service intervals, consult a certified technician or your local Acura dealership.
Summary
The 2010 Acura ZDX’s 3.7L V6 takes about 5.5 quarts (5.2 liters) of engine oil for a full change with a new filter. Use the dipstick to confirm the final level and follow the manufacturer’s specifications for oil type and service interval to maintain optimal engine health.
How much oil does a 2.4 L Acura take?
Engine Oil
Capacity: 4.2 quarts. w/of. After refill check oil level.
How many quarts of oil does a 2010 Acura ZDX take?
4.5 quarts
How much oil does a 2010 Acura RDX 2.3 take?
5Qts
5Qts Genuine Acura Full Synthetic Engine Oil 5w20.
What kind of oil does a 2010 Acura take?
If you own a TL between model years 2004-2014, your engine's recommended oil is 5W-20, a fully synthetic oil; if your Acura TL model is even older, from model years 1999-2003, the most versatile and safe oil to use in your engine is 5W-30 synthetic oil.
