How much oil does a 2010 Chevy Express 4.8 take?
The 2010 Chevy Express 4.8 takes 5 quarts of oil for a standard oil change. This includes the oil filter replacement and refilling the engine oil to the proper level.
Detailed Oil Change Specifications for the 2010 Chevy Express 4.8
The 2010 Chevy Express 4.8-liter V8 engine requires the following oil change specifications:
- Oil capacity: 5 quarts
- Oil filter: GM part number PF46
- Oil type: 5W-30 synthetic blend motor oil
It's important to use the recommended oil type and change the oil and filter at the intervals specified in the owner's manual to ensure the engine runs smoothly and efficiently.
Tips for Properly Changing the Oil in a 2010 Chevy Express 4.8
- Park the vehicle on a level surface and apply the parking brake.
- Allow the engine to cool completely before beginning the oil change.
- Locate the oil drain plug, usually on the bottom of the oil pan, and place a drain pan underneath.
- Unscrew the drain plug and allow the old oil to fully drain.
- Locate the oil filter, typically accessible from the top or side of the engine, and remove it using an oil filter wrench.
- Apply a thin coat of new oil to the gasket of the new filter before installing it.
- Replace the drain plug and tighten it securely.
- Unscrew the oil fill cap and pour in 5 quarts of the recommended 5W-30 synthetic blend motor oil.
- Replace the oil fill cap and start the engine, checking for any leaks.
- Allow the engine to run for a few minutes, then check the oil level and top up if necessary.
Following these steps will ensure your 2010 Chevy Express 4.8 is properly serviced with the correct amount and type of engine oil.
