How much oil does a 2016 Ford Transit 2.5 take?
The 2016 Transit 2.5L engine uses about 5 quarts (roughly 4.7 liters) of engine oil with the filter installed.
What follows explains the capacity in more detail, including typical ranges, the recommended oil grade, and practical tips for checking and maintaining oil in a van that earns its keep on the road.
Official capacity and what it means for you
For the 2.5L Duratec inline-four used in many 2016 Transits, the factory capacity with the oil filter installed is typically around 5 quarts (4.7 liters). Some very minor variations can occur by market, trim, or oil pan design, but the 4.7–5.0-quart range is commonly cited by sources and service manuals.
When performing an oil change, draining the old oil and refilling to the full mark should bring you to this total. Always confirm by checking the dipstick after adding oil and before starting the engine.
Oil grade and climate considerations
The standard viscosity recommended for most 2016 Transits is SAE 5W-20. In hot climates, higher-viscosity options like SAE 5W-30 may be acceptable if specified by Ford for your market or particular engine build. Always follow the owner’s manual or your Ford dealer’s guidance for your VIN.
Recommended oil and capacity at a glance:
- Oil capacity with filter: about 5 quarts (4.7 liters)
- Recommended oil grade: SAE 5W-20 for most regions; SAE 5W-30 can be used in hotter climates if approved by Ford
Keep in mind that exact specifications can vary by region and vehicle configuration, so checking the owner’s manual or contacting a dealer is a good precaution.
Practical steps for a routine oil change
When performing an oil change on a 2016 Transit with the 2.5L engine, you’ll typically:
- Warm the engine briefly, then shut off and secure the vehicle.
- Drain the old oil from the pan into an appropriate container.
- Replace the oil filter with a new unit.
- Refill with about 5 quarts of 5W-20 oil, then run the engine and check for leaks.
- Turn off the engine, wait a few minutes, and recheck the oil level with the dipstick; add more if needed to reach the full mark.
Following these steps helps ensure proper lubrication and avoids under- or overfilling the sump.
Verifying the correct capacity for your vehicle
Because small variations exist, always check the owner's manual or a Ford service bulletin for precise capacity for your VIN. For many 2016 Transit 2.5L builds, the official capacity with filter is about 5 quarts. If you’re unsure, contact a Ford dealer or a qualified mechanic to confirm the exact specification for your vehicle.
Summary
The 2016 Ford Transit 2.5 takes roughly 5 quarts (about 4.7 liters) of engine oil with a new filter, using SAE 5W-20 as the standard grade in most markets. Verify exact capacity and grade for your VIN in the owner’s manual or at a Ford dealer, and always check the oil level after a change to ensure accuracy.
