How much oil does a 2.4 l Dodge Journey take?
The Dodge Journey with a 2.4-liter engine generally takes about 4.5 quarts (4.3 liters) of engine oil when changing the oil with a new filter. Exact capacity can vary slightly by year and engine variant, so always verify the specification in your owner's manual or with a dealership for your specific model.
Engine variants and official capacity
Across the Journey’s production run, two 2.4-liter engines were used. Although their capacities are similar, slight differences may exist depending on the variant and whether the oil filter is included in the measurement.
- 2.4L World Gas Engine (early models): typically about 4.0–4.5 quarts with a filter; around 4.0 quarts without a filter.
- 2.4L Tigershark (later models): commonly about 4.5 quarts with a filter; many configurations sit in the 4.2–4.5 quart range depending on setup.
Note: These figures are general guidelines. Your manual or service bulletin will provide the definitive capacity for your year and trim.
How to fill and check the oil safely
If you’re performing an oil change or topping off, use this quick checklist to ensure you reach the correct level.
- Gather the correct oil grade, a new oil filter, a drain pan, and basic tools.
- Run the engine briefly to warm the oil, then park on level ground and turn the engine off. Let the oil settle for 5–10 minutes.
- Carefully remove the drain plug and drain the old oil into the pan. Replace and tighten the drain plug.
- Install a new oil filter (if changing it) and begin by adding about 4.0–4.5 quarts of the recommended oil.
- With the engine off, check the oil level using the dipstick. Wipe, reinsert fully, then pull out to read. The level should be between the Min and Max marks.
- If the level is below the Full mark, add small amounts (0.25 quart increments) and recheck until it reads within the full range. Start the engine, run briefly, and recheck again if needed.
These steps provide a safe, standard approach to changing or topping off oil and ensuring your engine remains properly lubricated.
Dipstick tips
Use the dipstick reading when the engine is at normal operating temperature or cold (as specified in the manual) for the most accurate result. Overfilling can cause excessive pressure and potential engine damage, while underfilling can lead to poor lubrication and wear.
Bottom line
For most Dodge Journey 2.4L engines, plan on about 4.5 quarts of oil with a new filter. Exact capacity can vary by engine variant and year, so check the owner’s manual or dealer data for your specific vehicle.
Summary: The Dodge Journey’s 2.4L engine typically requires roughly 4.5 quarts of oil with a filter, with minor variations by year and variant. Always verify the exact figure in your manual and follow proper oil change procedures.
