How much oil does a 3.5 L Taurus take?
The 3.5 L Taurus engine typically takes about 6 quarts (roughly 5.7 liters) of oil with a new filter.
Typical oil capacity for the 3.5 L Taurus engines
Below are the general figures you’ll encounter for a 3.5 L Taurus, noting that exact numbers depend on whether you replace the oil filter and on the specific engine variant. Use these as a baseline and verify with official documentation for your car.
- Oil capacity with filter: 6 quarts (5.7 liters)
- Oil capacity without filter (drain and refill only): about 5 quarts (4.7 liters)
- Recommended oil viscosity: typically 5W-20 (or the specification printed in your manual); confirm for your year and climate
These figures reflect the common specification across 3.5 L Ti-VCT V6 variants and the 3.5 L EcoBoost variants used in higher-performance Taurus models. Always confirm the exact capacity for your exact model year and engine code.
How to verify the correct amount for your car
Because Ford updated engines and service procedures across generations, the safest approach is to check:
- The owner's manual or the maintenance section of Ford’s official site
- The under-hood engine oil fill label on many vehicles
- Your vehicle’s service sticker or a Ford dealer service bulletin for your model year
After performing an oil change, use the dipstick to confirm the level is within the recommended range. If you’ve replaced the filter, start the engine, idle a few moments, turn it off, wait a couple of minutes, then recheck and top up as needed to stay within the correct range.
Choosing the right oil and change interval
Ford commonly recommends a 5W-20 oil for many 3.5 L Taurus engines, using either a conventional, synthetic blend, or full synthetic depending on the model year and climate. For hot climates or high-load conditions, some variants may specify 5W-30. Always follow the exact specification listed in your owner’s manual and use the recommended change interval for normal vs. severe driving conditions.
Summary
In short, expect about 6 quarts (5.7 liters) of oil with a new filter for most 3.5 L Taurus engines, and about 5 quarts (4.7 liters) if you drain and refill without changing the filter. Confirm the precise capacity for your exact year and engine variant in the owner’s manual or Ford’s official specifications, and adhere to the recommended oil type and change interval to keep the engine running smoothly.
