How much oil does a 3.5 L v6 Acura take?
Typically about 5.5 quarts (roughly 5.2 liters) of engine oil, including the oil filter, for most Acura 3.5L V6 engines. This is the common specification for many models that use the J35 family. Exact capacity can vary by model year and variant, so always verify with the owner's manual or service data for your exact vehicle.
Typical oil capacity for the 3.5L V6 family
The 3.5L V6 family used across Acura models such as the TL and MDX generally lists an oil capacity around 5.5 quarts when performing a standard oil change with a new filter. Some years may present a small range depending on the specific variant and whether the filter is replaced. The figure below represents the typical capacity cited by service guides.
- 5.5 quarts (about 5.2 liters) of oil, including the filter, for a standard oil change on most 3.5L Acura V6 engines.
Always confirm the exact specification for your specific model year and trim in your owner's manual or on the service data by VIN.
How to confirm the exact capacity for your vehicle
To ensure you add the right amount of oil, follow these steps before an oil change:
- Check the owner's manual for the model- and year-specific engine oil capacity.
- If needed, pull the service data sheet for your exact VIN from the manufacturer or dealer portal.
- Look at the under-hood sticker or near the engine bay for capacity and grade recommendations.
- Consult your Acura dealer or a qualified technician if the information remains unclear.
Following these steps helps ensure the engine is filled to the correct level and prevents overfill or underfill issues.
Tips for performing a proper oil change
When changing oil on a 3.5L V6 Acura, use the recommended oil grade for your climate and model year (often 0W-20 or 5W-30, depending on region). Replace the oil filter, use a new oil drain plug washer if applicable, and thoroughly check for leaks after refilling. After refilling, run the engine briefly and recheck the dipstick to confirm the level is at the full mark with the engine warm.
Summary
In summary, the typical oil capacity for a 3.5 L V6 Acura is about 5.5 quarts (5.2 liters) with the filter included, though you should verify the exact figure for your specific model year and trim. Following the correct procedure ensures optimal engine lubrication and longevity.
