How much oil does a 4.7 Magnum take?
Typically 5 quarts (about 4.7 liters) of engine oil with a new filter; some configurations may use slightly more or less. Always verify the exact spec for your vehicle in the owner's manual or by checking the dipstick after a change.
Oil capacity at a glance
The following figures reflect common factory specifications for the 4.7L Magnum V8. Exact capacity can vary by model year, oil cooler installation, and pan design. Use the dipstick and manual as your final reference.
- 5 quarts (approximately 4.7 liters) with a new filter
- 4.5 quarts (approximately 4.3 liters) without the filter
- Up to about 6 quarts (approximately 5.7 liters) for engines with additional oil cooling, larger pans, or regional variations
In practice, most 4.7L Magnum oil changes start with about 5 quarts, then are topped up to the full mark after running the engine and allowing oil to settle.
What can affect the exact amount?
Several factors can shift the precise quantity you need when refilling after an oil change. Pan size, the presence of an oil cooler, and differences in manufacturer specifications across model years all play a role.
Common configurations and notes
Engine variants, optional oil cooling hardware, and changes in the oil pan design can lead to small differences in capacity. Always confirm with your vehicle’s documentation and use the dipstick to achieve the correct level.
Step-by-step: how to perform an oil change on a 4.7 Magnum
Below is a practical sequence you can follow to ensure you use the correct amount of oil and achieve a proper fill. This list is intended to accompany typical, technician-approved procedures.
- Warm the engine for a few minutes so the oil flows out smoothly.
- Turn off the engine and safely raise the vehicle if needed to access the drain plug.
- Place a drain pan beneath the oil pan and remove the drain plug to allow the old oil to drain completely.
- Remove and replace the oil filter, ensuring the gasket is reseated properly.
- reinstall the drain plug and snug it to the manufacturer’s torque specification.
- Slowly add 5 quarts of new oil, using a funnel to minimize spills.
- Start the engine and let it run for a minute, then shut it off and wait a few minutes for the oil to settle.
- Check the oil level with the dipstick and top up in small increments until it reaches the full mark.
Following these steps helps ensure you reach the correct oil level without overfilling, which can cause pressure issues or leaks.
Where to find official specs
Always consult your owner's manual for the exact oil capacity for your specific 4.7 Magnum configuration. If you don’t have the manual handy, your dealer’s service department or Chrysler/Mopar technical resources can confirm the correct specification for your year and options.
Summary
The typical oil capacity for a 4.7 Magnum V8 is about 5 quarts with a new filter. Variations exist depending on model year, the presence of an oil cooler, and pan design. Verify with the vehicle’s documentation and use the dipstick to ensure the oil level is correct after a change. When in doubt, start with 5 quarts and top off gradually to the full mark after running the engine and allowing the oil to settle.
What kind of oil does a 2005 Dodge Ram 4.7 take?
The recommended oil for a 2005 Dodge Ram 4.7L is 5W-30. You will need approximately 6 quarts of oil when replacing the filter. It is best to use a high-quality oil, such as a full synthetic or a full synthetic blend, that meets the specifications for the engine.
- Oil Type: 5W-30
- Capacity: 6 quarts (with filter change)
- Recommendation: Use a full synthetic or a high-quality synthetic blend for optimal engine protection.
- Verification: You can also verify the recommended oil type by checking the oil filler cap on the engine.
What kind of oil does a 4.7 take?
According to the owner's manual, 5W-30 is the preferred oil for both the 4.7L and the 4.7L High Output engines and is best for environmental operating temperatures below 100ºF.
What kind of oil does a 2003 Dodge Dakota 4.7 take?
The recommended oil for a 2003 Dodge Dakota 4.7L is SAE 5W-30. The engine requires about 6 quarts of oil when changing the filter, and you can also use 10W-30 if 5W-30 is unavailable and the temperature is above -18∘Cnegative 18 raised to the composed with power cap C−18∘𝐶 (0∘F0 raised to the composed with power cap F0∘𝐹).
- Viscosity: SAE 5W-30 is the preferred viscosity. SAE 10W-30 can be used if ambient temperatures are consistently above -18∘Cnegative 18 raised to the composed with power cap C−18∘𝐶 (0∘F0 raised to the composed with power cap F0∘𝐹).
- Capacity: Approximately 6 quarts of oil are needed when changing the oil filter.
- Type: Full synthetic or synthetic blend oils are recommended for better performance and longer intervals, but conventional oil is also an option.
How many quarts of oil does a 2002 Dodge Ram 1500 4.7 take?
A 2002 Dodge Ram 1500 with a 4.7L engine takes 6 quarts of oil with a filter change. It is recommended to use 5W-30 engine oil and to always check the dipstick level after refilling, even if you've added the correct amount, as readings can vary.
- Oil capacity: 6 quarts (with filter)
- Recommended oil grade: 5W-30
- Before checking: Start the engine, let it run briefly, then check the level with the dipstick while the engine is cool and the truck is on a level surface.
