How much oil does a 5.7 HEMI truck take?
The typical oil capacity for a 5.7L HEMI-powered truck is about 7 quarts (roughly 6.6 liters) of engine oil when performing a full oil change with a new filter. Exact amounts can vary by model year and configuration, so always verify with the owner's manual or under-hood labels.
Oil Capacity Basics for the 5.7L HEMI
The 5.7L HEMI V8 is used across several light-duty trucks and SUVs, including RAM 1500s, as well as other Dodge and Jeep models. While the engine family shares a common design, the official oil capacity is typically listed as around 7 quarts with a filter, with slightly less without a filter. Variations can occur due to model year, oil cooler options, and filter size.
Below are the standard capacity figures you’ll commonly encounter for 5.7L HEMI installations. It assumes a full oil change with a new filter; removing the filter reduces capacity by roughly one quart.
- 7 quarts (6.6 liters) of engine oil with the filter installed
- About 6 quarts (roughly 5.7 liters) without the filter
Remember, your exact figure depends on the vehicle and year. Always confirm using the owner's manual or the under-hood oil specification sticker.
Model-Year and Vehicle-Specific Notes
While many 5.7L HEMI installations share a standard capacity around 7 quarts with a filter, there are occasional nuances by model and year. For example, RAM 1500 pickups and some Jeep/Dodge applications generally follow the 7-quart guideline, but pan size, accessory equipment, and filter type can cause small variations.
Factors that can influence the stated capacity
Several factors can shift the exact amount required for a proper fill, even if the engine family remains the same. These include the presence of an oil cooler, aftermarket or OEM filter differences, and changes to the oil pan or baffle design in newer specifications.
In practice, consult the specific vehicle’s manual or the oil-change specification sticker under the hood to confirm the precise requirement for your exact year and model.
How to Check and Maintain Oil Level in a 5.7 HEMI
Maintaining the correct oil level is essential for engine health. Here are the standard steps to check and top off oil after a change or during routine maintenance.
- Park on level ground and run the engine briefly to warm oil, then turn it off and wait about 5–10 minutes for the oil to settle.
- Pull the hood latch, locate the oil dipstick, and pull it out. Wipe it clean, reinsert fully, then pull it out again to read the level.
- Check the dipstick markings: aim for the full (F) mark or between the min and max indicators, depending on your dipstick design.
- If low, add small amounts of the recommended oil weight (per your manual) and recheck in increments to avoid overfilling.
- After topping up, run the engine for a minute, turn it off, and recheck the level once more after a few minutes of settling.
- Dispose of used oil and filter properly at an authorized facility if you’ve performed a replacement.
Following these steps helps ensure you reach the correct oil level and maintain proper engine lubrication and performance.
Summary
For most 5.7L HEMI trucks, the standard oil capacity is about 7 quarts (6.6 liters) when changing the oil with a new filter. Without a filter, the capacity is typically around 6 quarts (roughly 5.7 liters). Always verify the exact figure for your specific year, model, and equipment by consulting the owner's manual or the vehicle’s label under the hood. Regularly checking oil level and using the recommended oil grade helps keep the 5.7L HEMI running smoothly.
How much oil does a 2014 RAM 1500 5.7 Hemi take?
Capacity: 7 quarts (with filter). After refill check oil level.
What kind of oil does a RAM 1500 5.7 Hemi take?
SAE 5W-20
The RAM 1500 with the 5.7L V8 HEMI engine requires SAE 5W-20 full synthetic oil. Using synthetic oil means you can schedule oil changes for every 10,000 miles.
How much oil does a 2018 RAM 1500 5.7 take?
7 quarts
How many quarts of oil does a 5.7 L Hemi take?
Seven quarts. Once you start it and let it run for a minute it'll read correctly on the dipstick.
