How much oil does a Crosstour V6 take?
The Crosstour with the 3.5L V6 typically uses about 5.0 quarts of engine oil when performing a full oil change with a new filter, which is roughly 4.7 liters. Exact capacity can vary by year, oil grade, and whether the filter is replaced.
The Honda Crosstour shares its 3.5-liter V6 platform with other family vehicles like the Pilot and certain Accord generations, so the published oil capacity follows the common 5-quart guideline. This article lays out the standard figures and practical considerations for owners and technicians checking or changing oil on this model.
Typical oil capacity for the Crosstour V6
Below are the common capacity figures used by owners and service technicians when performing routine oil changes on a Crosstour equipped with the 3.5L V6. They assume a full change with the filter replaced.
- 5.0 quarts (4.7 liters) of engine oil with the filter replaced (typical for the 3.5L Crosstour V6).
- 4.5 quarts (4.3 liters) if you do not replace the oil filter during the change, or in some very specific service variants.
Note: Years and trim levels can introduce slight variances. Always verify with the owner's manual or a dealership service bulletin for your exact year and oil specification. After filling, use the dipstick to confirm the level and top off as needed.
Practical oil-change steps for the Crosstour V6
Before carrying out an oil change, prepare by gathering the necessary tools and ensuring the vehicle is safely supported. The following steps outline a standard process for a Crosstour V6 with a 3.5L engine.
- Warm up the engine to operating temperature, then turn off and secure the vehicle on level ground.
- Lift the front of the Crosstour and support with jack stands if you're using a ramp or jack system.
- Place a drain pan beneath the engine's oil pan and remove the drain plug to let old oil drain completely.
- Remove and replace the oil filter with a new unit, applying a light coat of new oil to the gasket.
- Reinstall the drain plug, then fill the engine with the recommended amount of oil (start with 4.7-5.0 quarts depending on the guidance above).
- Run the engine briefly, check for leaks, recheck the oil level with the dipstick, and top off to the correct mark if needed.
Concluding paragraph: Consistent oil changes at the recommended interval maintain engine performance and longevity, and using the correct capacity as a baseline helps avoid overfilling or underfilling the crankcase.
Summary
The Crosstour V6 generally takes about 5 quarts (roughly 4.7 liters) of engine oil with a new filter for a full oil change. Minor variations can occur by year, filter type, and oil specification, so always reference the owner's manual and verify with the service department. A proper oil change includes checking level after fill and ensuring no leaks after running the engine.
How many quarts of oil does a Honda Crosstour take?
The oil capacity for a Honda Crosstour depends on the engine. For the 4-cylinder engine, it is 4.5 quarts (with filter). For the 6-cylinder engine, it is also 4.5 quarts with a filter, or 4.2 quarts without a filter. Always check your owner's manual for the exact amount needed for your specific model and engine.
- 4-Cylinder Engine: 4.5 quarts with filter.
- 6-Cylinder Engine: 4.5 quarts with filter, 4.2 quarts without filter.
How much oil does a 2012 Honda Crosstour 3.5 take?
Engine Oil
Capacity: 4.5 quarts (with filter). After refill check oil level.
How much oil do you put in a 3.6 L V6?
The oil capacity for a 3.6L V6 engine is typically 5 to 6 quarts, but it varies by vehicle model and year. For a 2020 Dodge Charger, it's around 5.9 quarts, while a 2023 Jeep Wrangler requires 5 quarts. Newer Jeeps, such as the 2016-2021 Grand Cherokee and Durango, often require 6 quarts. Always check your specific owner's manual for the most accurate information, as it can differ even within the same engine family.
- 5 quarts: Common in many models like the 2020 Jeep Wrangler and 2025 Ram 1500.
- 5.9 quarts: The capacity for some models, such as the 2020 Dodge Charger.
- 6 quarts: Required for certain vehicles, including the 2013 JK Jeep Wrangler and some 2016-2021 Grand Cherokee and Durango models.
- Check your owner's manual: This is the most reliable source for your specific vehicle's oil capacity.
- After refilling: It's important to check the oil level with the dipstick after refilling to ensure it is correct.
How much oil does a 2010 Honda Crosstour 3.5 take?
4.5 quarts
Oil Grade: API*
| Viscosity: | 0W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts (with filter). After refill check oil level. |
| Capacity: | 4.2 quarts. w/of. After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. Only use an OE drain plug. |
