How much oil does a defender 2.2 take?
The Defender 2.2 diesel typically needs about 6.5–7.0 liters of engine oil for a full drain and refill with a new filter, with 6.8 liters being a common figure.
What influences the amount
The oil capacity depends on the exact engine code (Duratorq 2.2 TDCi variants), model year, and whether you replace the oil filter during the change. Most official service data cite a range in the mid-to-high six-liter area; always verify with your manual or a Land Rover dealer for your VIN.
Typical capacity range for Defender 2.2 engines
Below are commonly cited figures for the 2.2 Duratorq diesel used in Defender models. Use these as guidance; your exact figure may differ slightly.
- Engine oil capacity (including filter): typically 6.5–7.0 liters (commonly around 6.8 L).
Always consult your owner's manual or Land Rover service data for the precise specification for your vehicle’s engine code and year.
Practical tips for oil changes
When performing an oil change, ensure you drain for the recommended time, replace the filter with the correct part, use the recommended grade (often 5W-30 or 5W-40 depending on climate and spec), and fill to the manufacturer’s specified level using a clean funnel. After topping up, check the level on a cold engine via the dipstick and adjust as necessary.
Conclusion
In short, plan on about 6.8 liters of engine oil for a full drain-and-fill on a Defender 2.2, but verify with your manual and engine code for exact figures. This ensures proper lubrication and engine longevity.
Summary
The Defender 2.2’s oil capacity is typically around 6.5–7.0 liters with the filter change, commonly about 6.8 liters. Exact numbers depend on engine variant and year; always confirm from official sources and measure with the dipstick after filling.
