How much oil does a Ford 10-speed transmission hold?
A Ford 10-speed automatic transmission typically holds between 12 and 15 quarts of transmission fluid. The exact amount can vary depending on the specific vehicle model and application.
Detailed Explanation
Ford's 10-speed automatic transmission is a high-performance gearbox found in a variety of the automaker's trucks, SUVs, and performance vehicles. This advanced transmission is designed to provide smooth, efficient power delivery and improved fuel economy compared to previous generation transmissions.
The amount of transmission fluid required to fill a Ford 10-speed unit can vary based on several factors:
- Vehicle Model: The fluid capacity may differ slightly between Ford F-150 trucks, Mustang sports cars, Expedition SUVs, and other models equipped with the 10-speed transmission.
- Transmission Variant: Ford offers both rear-wheel-drive and all-wheel-drive versions of the 10-speed, which can impact the fluid volume needed.
- Fluid Type: Ford specifies the use of Mercon ULV transmission fluid, which has a different density than older Mercon V or Mercon LV fluids.
In general, most Ford 10-speed transmissions require between 12 and 15 quarts of fluid to fill the system from empty. Owners should always refer to their vehicle's owner's manual or Ford service information for the exact fluid capacity specification for their particular model.
How much fluid does a 10R80 take?
With an appropriate pump and fitting, add 3.3 L of the correct fluid (WSS-M2C949-A or MERCON™ ULV) as an initial fill via the dipstick tube. This will allow you to start the engine. NOTE: If the transmission is new or has been reconditioned add 11.35 L.
How much oil does the Eaton UltraShift hold?
Oil Capacity: • Approx. 28 pints [13.3 liters].
How much fluid does a 10 speed transmission hold?
11 to 12 liters
The capacity is 11 to 12 liters.
How much oil does a 10 speed Eaton Fuller transmission hold?
26 pints
Oil Capacity: 10-speed: Approx. 26 pints [12 liters]. Integral oil pump available. Pump standard on 1450, 1650 and 1850 series.
How many quarts does a Ford 10 speed transmission take?
Since the transmission is 14 qts for a full fill, this change does about half of the fluid.
Is the Ford 10 speed transmission any good?
Q: Is the Ford 10R80 a good transmission? A: Known as a less-than-reliable unit, the 10 Speed Ford 10R80 transmission is a fertile breeding ground for a variety of problems. This includes but is not limited to: Valve body crossleakage, burnt clutches, damaged clutch hubs, stripped shells and much more.
How much transmission fluid does a 2018 Ford F-150 10 speed hold?
Capacity: 10 speed 10R80 Total Fill 13.1 quarts.
How many quarts are in 10R80?
13 qts.
13 qts. Weight (kg / lbs.)
What kind of transmission fluid does a Ford 10 speed take?
ULV ATF
ULV ATF is a full-synthetic, ultra-low viscosity transmission fluid for the latest General Motors and Ford automatic transmission with 9 and 10 speed gears, specifically recommended for Ford/GM 10R80 and select Ford F-150 and Raptor trucks.
How often should you change the transmission fluid in a Ford 10 speed?
once every 30,000-60,000 miles
Typically, a Ford F-150 requires a transmission fluid change once every 30,000-60,000 miles. Since many drivers only add 12,000 miles to the odometer annually, you can expect to need a transmission fluid change only once every few years.
