How much oil does a Toyota 86 take?
About 4.5 quarts of engine oil with a new filter for the 2.0L FA20 version, and roughly 5.0 quarts with a filter for the newer 2.4L FA24 version. Always verify the exact figure in the owner's manual and use the correct oil grade, typically 0W-20 in many markets.
Oil capacity by generation
The Toyota 86 lineup spans two generations with different engines and capacities. Below are the typical figures for the two generations and their engines.
First generation (2012–2020)
The 1st-generation 86 used a 2.0-liter FA20 engine, and its oil capacity with a new filter sits in the mid-4-quart range. Values can vary slightly by model year and filter type.
- Approx. 4.4–4.8 quarts (4.2–4.5 liters) of engine oil with the filter installed.
Note: Actual capacity can differ by year, trim, and whether you replace the oil filter during the change. Always verify with the dipstick and the manual.
Second generation (2022–present)
The 2nd-generation 86 uses a 2.4-liter FA24 engine, which requires a larger oil supply.
- Approximately 5.0 quarts (4.7 liters) of engine oil with the filter installed.
As always, confirm the exact specification in your owner's manual and by checking the dipstick after a fill.
Oil grade and maintenance tips
Choosing the right oil grade and following a proper fill procedure helps protect the engine. Here is a practical guide to ensure you use the correct oil and fill it accurately.
Follow these steps to perform an oil change and ensure an accurate oil level:
- Prepare the correct oil type and amount for your generation (approximately 4.5 quarts for FA20; about 5.0 quarts for FA24) and a new filter.
- Warm the engine to operating temperature, then shut off and park on level ground.
- Drain the old oil completely and replace the oil filter according to the service manual.
- Install the drain plug with the correct torque and slowly add oil in small increments, using a funnel to avoid spills.
- After adding roughly the full capacity, run the engine for a minute, turn it off, wait a few minutes, and recheck the level with the dipstick; top up as needed to reach the full mark.
- Dispose of used oil and the old filter responsibly and recycle.
In practice, the listed capacities represent typical installations. Always verify with the dipstick and follow the exact guidance in your owner's manual for your particular model and market.
Where to verify and additional notes
Exact oil capacity and the recommended grade can vary by market, trim level, and whether your engine is the 2.0L FA20 or the 2.4L FA24. The owner's manual, dealership service bulletins, and the oil-fill cap on the engine cover are authoritative sources. If you are unsure, consult a qualified technician or your local Toyota/Subaru dealer for the precise specification for your vehicle.
Summary
The Toyota 86’s oil capacity depends on the generation: roughly 4.4–4.8 quarts for the 2.0L FA20 engine in the first generation, and about 5.0 quarts for the 2.4L FA24 engine in the second generation. Use a compatible synthetic oil (commonly 0W-20 in many markets) and always confirm the exact figure and grade in the owner’s manual, then verify the level with the dipstick after filling. Regular checks and proper disposal of used oil are essential to maintain engine health.
