How much oil does a Toyota Hilux 3.0 D4D take?
The Toyota Hilux 3.0 D-4D typically requires about 6 liters of engine oil when performing a full oil change with a new filter, with a typical range around 6.0–6.4 liters depending on the exact filter and market.
Understanding the 3.0 D-4D engine
The Hilux 3.0 D-4D is powered by the 1KD-FTV turbo diesel engine. This 3.0-liter unit is designed for durability and efficiency, commonly used in a range of Toyota pickups and SUVs from the mid-2000s onward. Oil capacity figures can vary slightly between model years and regional specifications, but the general guideline remains around six liters with a fresh filter.
Oil capacity specifics
When performing a standard oil change with a new filter, plan for roughly 6.0 liters (about 6.3 US quarts) of engine oil. Some service manuals and regional variants list a capacity up to about 6.4 liters depending on the exact filter size and drainage performed. Always confirm the precise figure for your exact vehicle year and market by checking the owner's manual or service information from Toyota.
Variations by year and market
Oil capacity can differ slightly based on production year, engine revision, and the filter used. If you are working from a service bulletin or aftermarket manual, you may see ranges such as 6.0–6.4 liters. For vehicles with different filter housing or drain procedures, the total fill after a full drain may vary by a small amount. When in doubt, always fill gradually to the recommended level on the dipstick after starting and checking for leaks.
Practical guidance: checking and filling
To correctly fill and verify oil for the Hilux 3.0 D-4D, follow these steps: park on level ground, engine cold, remove the dipstick to check the current level, and add oil in small increments, rechecking with the dipstick until the level sits between the minimum and maximum marks. Use the oil grade recommended by Toyota for your climate (commonly 5W-30 or 5W-40 synthetic in many markets) and replace the oil filter with every oil change to ensure optimal filtration and engine protection. After a full drain and refill, allow the engine to run briefly, recheck for leaks, and recheck the dipstick once more.
Summary
For a Toyota Hilux 3.0 D-4D, plan for about 6.0 liters of engine oil when performing a full oil change with a new filter, with a typical practical range up to 6.4 liters depending on the filter and regional specifications. Use the recommended oil grade for your climate, usually 5W-30 or 5W-40, and always verify the exact specification in your vehicle’s manual for year- and market-specific guidance. Regular checks via the dipstick help ensure the oil level remains within the correct range between service intervals.
How much oil does a Hilux 3.0 D4D take?
around 6.9 litres
However, the average Hilux D4D engine oil capacity is around 6.9 litres. Remember, it isn't as simple as topping up the existing oil. When the oil gets dirty you'll need to drain it completely before replacing it.
What kind of oil does a 3.0 diesel take?
Chevrolet/GMC 3.0L Duramax 0W-20 Full Synthetic Oil Change Kit 2020-2025.
What kind of oil does a Toyota Hilux diesel take?
0W-30
0W-30 is preferred viscosity.
How much oil does a Toyota 3.0 take?
Engine Oil
4.8 quarts (with filter).
