How much transmission fluid does a 2000 Ford Excursion 7.3 hold?
Approximately 19 quarts of automatic transmission fluid for a complete fill on the 2000 Ford Excursion 7.3 with the 4R100 transmission. A standard pan drain and refill typically replaces about 8–10 quarts, while a full system flush that includes the torque converter can require roughly 18–24 quarts, depending on the service method and vehicle condition.
Understanding the capacity
The Excursion's 7.3L diesel uses Ford's 4R100 automatic transmission. Total fluid capacity depends on the amount stored in the pan, the torque converter, and the cooler loop. Different service methods exchange different amounts of fluid.
Typical service scenarios
Here are common approaches and their approximate ATF demands for this setup. Use these as rough estimates and verify with Ford's specifications or a trusted shop.
- Pan drain and fill (no converter drain): about 8–10 quarts.
- Pan drain, filter change, and one refill: roughly 12–15 quarts.
- Full system flush or complete replacement including torque converter: about 18–24 quarts.
Conclusion: The exact amount depends on the service method. For routine maintenance, plan on 12–15 quarts being exchanged; for a full flush or converter-containing replacement, you may need up to 24 quarts.
Practical tips for checking and maintenance
- Always use the ATF type specified by Ford for the 4R100 (check the owner's manual). Most mid-2000s 4R100 units require Dexron/Mercon-compatible fluid.
- Check level on level ground, engine warm, and after a proper drive cycle as specified in the manual.
- When unsure, perform a full drain and replace the filter to ensure proper fluid flow and longevity.
Summary
The 2000 Excursion’s 4R100 transmission holds roughly 19 quarts of ATF for a full system fill, with variations depending on whether you drain just the pan or perform a complete flush including the torque converter. Planning around 8–10 quarts for a simple pan drain, up to 18–24 quarts for a full flush, provides a practical guideline for maintenance and budgeting.
What kind of transmission fluid does a 2000 7.3 powerstroke take?
Mercon V ATF
| Transmission | Trans Fluid | Capacity |
|---|---|---|
| 4R100 4-Speed | Mercon V ATF | 17.1-17.7 quarts Dry Fill Capacity |
| ZF S6-650 6-Speed | Mercon V ATF | 5.8 quarts |
What transmission fluid goes in a 2000 Ford Excursion?
MERCON- V automatic transmission fluid
MERCON- V automatic transmission fluid, Motorcraft part #XT-5-QM.
How many quarts of transmission fluid does a Ford excursion take?
The Ford Excursion transmission fluid capacity depends on the year and engine but is typically around 17 to 18 quarts for a total system fill. For a pan drop and filter change, you will only need about 6 to 8 quarts initially, as a significant amount of fluid remains in the torque converter.
Total system capacity
- Total fill: The complete capacity of the transmission system is roughly 17 to 18 quarts.
- Note: Do not rely solely on the dipstick for filling the entire system at once, as the torque converter holds a large amount of fluid.
Pan drop and filter change capacity
- When draining the pan: Expect to drain about 6 to 8 quarts of fluid.
- Initial refill: You will need approximately 6 to 8 quarts to refill the transmission after replacing the filter and draining the pan.
- Total for a full service: When performing a complete fluid flush, it is best to purchase around 20 quarts of fluid to ensure all old fluid is purged and replaced.
What type of fluid to use
- MERCON V: This is the recommended fluid for most Ford Excursions with a 4R100 transmission.
- Check the owner's manual: It is always best to consult your specific owner's manual for the exact fluid type and capacity.
How many quarts of transmission fluid does a 7.3 diesel take?
A 7.3L diesel transmission holds between approximately 13 and 17.7 quarts of fluid, depending on the specific transmission model and whether it's a dry fill or a service fill. A standard service (fluid and filter change) on an automatic transmission typically requires 13-14 quarts, while a full dry fill can be as much as 17.7 quarts. A manual transmission will require a much smaller amount, around 3.4 to 5.8 quarts depending on the specific manual gearbox.
Automatic transmission
- Service (fluid and filter change): 13–14 quarts
- Dry fill: Up to 17.7 quarts
Manual transmission
- ZF S5-47 5-speed: 3.4 quarts
- ZF S6 6-speed: 5.8 quarts
Important notes
- Always consult your owner's manual for the exact capacity for your specific vehicle and transmission model.
- To get an accurate reading for a service fill, drain the old fluid, replace the filter, and refill the new fluid while checking the dipstick as recommended for a warm engine on level ground.
