How much transmission fluid does a 2014 Dodge Charger take?
Most 2014 Chargers with an automatic transmission take roughly 9 to 10 quarts of ATF for a full fill; the exact amount depends on the specific transmission variant and whether you’re performing a complete service or a simple pan drain and fill.
What transmission does the 2014 Charger use?
The 2014 Charger offered different automatic transmissions depending on trim and engine. The most common setup is the 8-speed TorqueFlite 8HP70, used in many V6 and V8 models, while a minority of configurations used a 5-speed automatic. Because capacities vary between transmissions, check your vehicle’s VIN or the official manual for the precise figure.
Transmission capacity by type
The following figures reflect typical total capacities for common 2014 Charger automatics. They are approximate and can vary by market, engine, and production date.
- 8-speed automatic (TorqueFlite 8HP70): total capacity about 9.5 quarts (approximately 9.0–9.8 quarts).
- 5-speed automatic (older 5L40-type): total capacity around 11.5–12.5 quarts.
Note that a simple drain-and-fill, which changes only the fluid in the pan, typically replaces roughly 4–7 quarts of ATF depending on the transmission and how much fluid remains in the torque converter and oil cooler. For a full service including the torque converter, you should plan on roughly the total capacity above.
Maintaining your transmission fluid
When planning a service, it’s important to use the recommended ATF specification for your vehicle. Dodge commonly specifies Dexron VI-compatible ATF for many transmissions in the Charger lineup. Always check the owner’s manual or a dealership service bulletin for the exact spec.
Step-by-step drain-and-fill guidance
If you’re performing your own transmission fluid change, these general steps are commonly followed. Always refer to the service manual for model-specific details and torque specs.
- Raise and support the car securely on level ground, with the engine warmed to operating temperature for easier drainage.
- Place a drain pan beneath the transmission pan and remove the pan bolts to drain the fluid fully.
- Remove and replace the transmission filter (if applicable) and gasket, then reinstall the pan with a new gasket.
- Lower the vehicle and use the correct fill procedures to add new ATF until the level is correct on a hot, level surface.
- Run the engine, cycle through the gears (P-R-N-D), and recheck the level, re-topping as needed.
Be mindful of the torque converter and fluid pickup; overfilling can cause foaming and pressure issues. If you’re unsure, a professional service is advised.
Summary
For a 2014 Dodge Charger, plan on roughly 9 to 10 quarts of ATF for a full transmission fill, with variations depending on the specific transmission model and whether you’re doing a full service or a simple pan drain and fill. Always verify with your VIN and the owner’s manual, and use the correct Dexron VI-compatible fluid as specified by Dodge. If in doubt, consult a trusted automotive technician.
