What is the PSI for Honda CRV?

The typical cold tire pressure for most Honda CR-Vs is 32 psi for the four main tires, with a 60 psi spare. Exact figures can vary by model year, tire size, and loading, so always verify on the door placard and in the owner's manual for your specific vehicle.

Understanding tire pressure for the CR-V

PSI, or pounds per square inch, is the standard measure used to describe how much air should be in the tires. “Cold” means the tires have not been driven more than a mile or warmed by driving, and readings can change with temperature. Honda specifies a baseline pressure to balance ride comfort, safety, and tire wear across typical driving conditions for the CR-V.

Where to find the exact numbers for your CR-V

Because the CR-V has spanned several generations with different tire sizes, the precise PSI can differ. The official figures are printed on the driver’s door jamb placard and are also listed in the vehicle’s owner's manual. Some models may also show tire information labels inside the glove box or fuel filler door.

Typical values you are likely to see on the placard for most CR-Vs are listed below as a baseline.

• Front tires: 32 psi (cold)


• Rear tires: 32 psi (cold)


• Spare tire: 60 psi (cold, for most temporary/spare tires)

These values represent standard, non-loaded operating conditions. If you regularly carry heavy cargo or passengers, or if you operate in extreme temperatures, always follow the placard guidance or the owner’s manual for any recommended adjustments.

Notes on model-year differences

Some CR-V generations may use slightly different targets due to alternate tire sizes or revised suspension tuning. When in doubt, trust the door placard and the manual specific to your vehicle’s year and trim.

PSI guidance by situation

Beyond the baseline numbers, you may adjust within the vehicle’s recommended range depending on load, driving conditions, and tire size. Use the following general guidelines as a reference, but always confirm against your specific placard.

• Standard use (typical daily driving with normal passengers and cargo): inflate to the placard-specified cold tire pressures, usually 32 psi front and rear.


• Heavy load or extended highway driving: avoid underinflation by ensuring pressures are within the recommended range; do not exceed the tire’s maximum pressure printed on the sidewall.


• Spare tire care: keep the spare at its recommended cold pressure (commonly 60 psi for many temporary spares) and check periodically.

Maintaining correct PSI helps with fuel efficiency, handling, braking, and tire wear. If you’re unsure about the proper target for your exact CR-V model, consult the placard or the owner’s manual.

How to check and maintain tire pressure

Regular checks are essential because tire pressure changes with temperature and time. Follow these steps to keep your CR-V's tires properly inflated.

1. Check tires when they are cold, ideally after the car has been stationary for a few hours or overnight.


2. Use a reliable gauge (digital or dial) and compare the reading to the placard values.


3. Inflate or release air as needed to reach the recommended cold psi on the placard for each tire (front and rear may be the same).


4. Recheck after you’ve driven a short distance (a few miles) to allow the tires to warm up; the reading may rise slightly when hot.


5. Do not forget to check and inflate the spare tire to its specified pressure.

If you notice persistent underinflation or overinflation, or if the tire pressures drift significantly over a short period, have the tires inspected by a professional to rule out leaks or other issues.

Summary

For most Honda CR-V models, the standard target for the four main tires is about 32 psi when cold, with a 60 psi spare for most temporary spares. Always verify the exact numbers on the vehicle’s door placard and in the owner’s manual, as tire size, model year, and loading can cause variations. Regularly checking and maintaining proper tire pressure supports safer handling, better fuel economy, and longer tire life.

Should my tires be 32 or 35 psi?

For most cars, the recommended tire pressure is between 32 and 35 psi, and you should use the pressure listed on the driver's side door jamb or in the owner's manual. The correct pressure can vary by vehicle, and the pressure on the tire's sidewall is a maximum, not the recommended value. Using the correct pressure ensures proper handling, fuel efficiency, and tire life, while using the wrong pressure can cause poor handling, reduced traction, and premature wear.
 
How to find the right pressure

• Check the sticker on the driver's side door jamb. This is the most reliable source for your specific vehicle. 
• Consult your owner's manual for the manufacturer's recommendation. 
• Note that the pressure should be checked when the tires are cold (before driving). 
• Don't use the pressure listed on the tire's sidewall, as this is the maximum pressure the tire can hold, not the recommended pressure for your car. 

Why the correct pressure is important

• Too low: Can lead to poor fuel economy, premature tire wear, and a higher risk of tire failure. 
• Too high: Can cause reduced traction, an uncomfortable ride, and rapid, uneven tire wear. 
• Correct pressure: Optimizes handling, safety, and fuel efficiency, and helps your tires last longer. 

What should tire pressure be for a Honda CR-V?

between 32 to 35 PSI
Understanding Tire Pressure
For a Honda CR-V, the recommended tire pressure typically ranges between 32 to 35 PSI.

What is the normal psi for Honda tires?

The correct Honda tire pressure is on a sticker inside the driver's side doorjamb and is typically between 32 and 35 PSI for sedans like the Civic and Accord, while SUVs may require 35 PSI. Always check the pressure when the tires are cold and use a gauge to inflate to the manufacturer's recommended level found on the sticker. If the TPMS light is on, it could be due to a significant temperature change or a low tire, so check the pressure first.
 
Where to find the correct pressure

• Open the driver's door: A yellow and white sticker is located on the doorjamb with the recommended tire pressure for your specific model. 
• Consult your owner's manual: The manual also contains the correct information. 

How to check and inflate

1. Check when tires are cold: This provides the most accurate reading, as pressure increases with heat from driving. 
2. Use a tire pressure gauge: Press the gauge onto the valve stem to get a reading. 
3. Inflate to the recommended PSI: Add air slowly to avoid over-inflation. You can use an air compressor at a gas station or a portable one. 
4. Check all four tires: Make sure each tire meets the recommended pressure. 

Common pressure levels

• Sedans (Civic, Accord): Approximately 32-35 PSI.
• SUVs (Pilot, Passport): Approximately 35 PSI. 

What to do if the TPMS light is on

• Check your tire pressure first, as temperature changes can trigger the sensor. 
• If a tire is low, inflate it to the correct pressure. You may need to drive for a few minutes to reset the system. 
• If the light remains on, or if you suspect a leak, see a mechanic for a professional inspection. 
• If you've recently rotated your tires or had a tire replaced, you may need to recalibrate the TPMS system. Navigate to the "TPMS Calibration" option in your vehicle's settings menu to do this. 

Is 40 psi good tire pressure?

No, 404040 psi is generally too high for most passenger cars and can result in a harsh ride, reduced traction, and uneven wear, as typical recommendations are between 303030 and 353535 psi. You should always check the manufacturer's recommended pressure for your specific vehicle, found on a sticker inside the driver's door or in the owner's manual. While 404040 psi might be appropriate for some heavier loads or larger vehicles like SUVs, it is a good practice to stick to the manufacturer's recommendation unless you have a specific reason for a higher pressure and understand the trade-offs. 
Why 404040 psi is often too high

• Harsh ride: Overinflated tires make the ride bumpy and uncomfortable, especially on uneven road surfaces. 
• Reduced traction: Less of the tire makes contact with the road, leading to poorer braking performance and less grip. 
• Uneven wear: The center of the tire tread may wear down faster than the edges. 

Where to find the correct tire pressure

• Driver's side door jamb: This is the most common location for the manufacturer's recommended tire pressure sticker. 
• Owner's manual: The manual will also contain the correct specifications for your vehicle. 
• Fuel filler door: Some vehicles have the sticker on the inside of the fuel filler door. 

When 404040 psi might be acceptable

• Heavier loads: If you are frequently carrying heavy cargo or multiple passengers, a slightly higher pressure might be needed, but still check your manual for the load-specific recommendation. 
• Larger vehicles: Some larger SUVs or light trucks may have a recommended cold pressure in this range, or higher. 
• Performance or special use: Some drivers, particularly those who enjoy a more responsive feel for spirited driving, may experiment with higher pressures, but this is not recommended for daily driving and can negatively impact other performance metrics. 

How to maintain proper tire pressure

• Check regularly: Check your tire pressure at least once a month and before long trips.
• Check when cold: Always check pressure when the tires are "cold," meaning the vehicle has been parked for at least a few hours.