Loading

What should the back tire pressure be on a Honda Accord?

The recommended back tire pressure for a Honda Accord is typically between 30-35 PSI (pounds per square inch). This range is specified by the vehicle manufacturer and can be found in the owner's manual or on a placard located inside the driver's side door jamb.


Importance of Proper Tire Pressure


Maintaining the correct tire pressure is crucial for the safety, performance, and fuel efficiency of your Honda Accord. Underinflated tires can lead to poor handling, increased wear and tear, and even blowouts, while overinflated tires can result in a harsher ride and premature tread wear. By keeping your tires inflated to the recommended pressure, you can optimize your vehicle's handling, improve gas mileage, and extend the life of your tires.


How to Check and Adjust Tire Pressure



  • Use a reliable tire pressure gauge to measure the pressure in each of your Accord's tires, including the spare.

  • Compare the measured pressure to the recommended PSI range, which can be found in your owner's manual or on the driver's side door jamb sticker.

  • If the pressure is too low, use an air compressor to inflate the tires to the proper level.

  • If the pressure is too high, release air from the tires until the correct PSI is reached.

  • Remember to check and adjust the tire pressure when the tires are cold, meaning the vehicle has been parked for at least three hours or driven less than a mile.


By following these steps, you can ensure that your Honda Accord's back tires are properly inflated, which will contribute to a safer, more efficient, and longer-lasting driving experience.

What is the ideal tire pressure for a Honda Accord?


32 PSI
Sedans like the Honda Civic or Honda Accord tire pressure should be 32 PSI (pounds per square inch) Honda SUVs like the Honda Passport or Pilot need 32 PSI for their tires. Other makes and models might need different pressures.



What should my back tire pressure be?


between 30 to 35 psi
The placard or manual should list the appropriate psi for both the front and rear tires, as they may be different. Most passenger cars' psi requirement will be between 30 to 35 psi, but several vehicles fall outside of that range and every vehicle will have specific requirements.



What should the rear tyre pressure be on a car?


Generally, the most commonly recommended tyre pressure is 32-35 psi for cars. If that is the case, even 36-38 psi will be fine for the user. Any pressure lesser than that is dangerous and can prove dangerous (like 28 psi). The tyre pressures for bikes are different from cars.



Should the tire pressure be higher in the front or rear?


In most cases, the recommended tyre pressure for your vehicle will be same for both the front and back tyres. However, some manufacturers may recommend different tyre pressure for the front and rear tyres when it is fully laden. In this instance, the recommendations tend to include a higher pressure in the rear tyres.



Should rear tires be less inflated?


Putting less in the rear may seem like a good idea on a pickup that is seldom loaded, but this can have the opposite effect of making the rear unstable, so we never recommend less air pressure in the rear of a truck.



Should front and back tires have same PSI?


All that having been said, most passenger cars use the same size tires front and rear, and so typically have the same recommended pressure.



Is 35 psi too high for a Honda Accord?


Incorrect tire pressure can lead to premature tire wear and potential damage. Sedan: The Honda Accord and Honda Civic require 32 PSI (pounds per square inch) for tire pressure. SUV: On the other hand, Honda SUVs such as the Honda Pilot or Passport need 35 PSI for their tires.



Is 35 tire pressure too high?


Ideal Tire Pressure
Tire pressure between 32 to 35 PSI is suitable for most vehicles. However, one can go as low as 20 PSI (although that is not recommended). Anything below 20 PSI is considered a flat tire. PSI stands for pounds per square inch.



How do you check rear tire pressure?


How to check tire pressure

  1. Remove the cap from the air valve on the tire, and put it somewhere you won't lose it.
  2. Press the tire gauge against the open valve stem for a second or two.
  3. Read the air pressure gauge.
  4. Compare this number with the recommended tire pressure.
  5. Replace the tire's air valve cap.



What is the 4 psi rule on tires?


As a general guide: << What Is The 4 PSI Rule? According to the 4 PSI rule, a correctly-inflated tire has its hot measurements (the pressure measured while hot) rise 4 PSI higher than its cold inflation pressures (the pressure measured while cold). >>


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.