What size are the CV axle nuts on a 2019 Toyota Camry?
The front CV axle nut is a 32 mm hex nut and should be torqued to about 177 ft-lbs (240 Nm).
Overview of the 2019 Camry CV axle nut size
The 2019 Toyota Camry’s outer CV joint uses a 32 mm hex nut to secure the axle to the hub. This size is standard for many Toyota front-wheel-drive models, though regional revisions can vary. When in doubt, always confirm with your vehicle’s service information for your exact VIN.
How to verify and install correctly:
- Size and socket: Use a 32 mm hex, typically a 6-point socket for best bite.
- Torque: Tighten to approximately 177 ft-lbs (240 Nm) according to the service manual.
- Security features: Some models may use a locking feature or cotter pin; replace as required by the manual.
Concluding: If you’re unsure about the exact size or torque for your car’s VIN, consult the official Toyota service information or a trusted repair manual before proceeding.
Practical guidance for working on the CV axle
Before removing or installing the CV axle nut, prepare with the right tools and precautions. The following steps help ensure you use the correct size and install it safely:
- Have a proper 32 mm, 6-point socket and a torque wrench capable of reaching 177 ft-lbs.
- Secure the vehicle, chock wheels, and use a breaker bar or impact tool to loosen the nut if needed.
- Inspect the CV boot, axle shaft, and hub assembly for wear or damage after disassembly.
Concluding: Using the correct size and torque is essential to prevent CV joint wear and ensure safe operation of the vehicle.
Summary
The 2019 Toyota Camry typically uses a 32 mm hex CV axle nut, tightened to about 177 ft-lbs (240 Nm). Always verify against your VIN-specific service data, use a proper 6-point socket, and follow the manufacturer’s torque specifications during installation.
