Where is the parking aid module on a Ford?
The parking aid (Park Assist) control module is typically mounted behind the bumper cover, inside the bumper fascia near a wheel well. Exact placement varies by model and year, so consult your owner's manual or Ford service diagrams for your specific vehicle.
What follows is a practical overview of where Ford generally places the Park Assist module, followed by steps to locate it on your own vehicle and guidance on what to do if you can’t find or diagnose it.
Common locations for the parking aid module in Ford vehicles
Ford uses a few standard mounting zones for the Park Assist control module. The following spots are the most frequently encountered across different models and generations.
- Behind the rear bumper cover, mounted to the bumper support or inner fascia near a wheel well.
- Inside the rear bumper reinforcement, often accessed by removing the bumper fascia.
- Behind the front bumper fascia on vehicles equipped with front park assist.
- In some crossovers and trucks, located in or near the spare tire well or rear cargo area behind trim panels.
Because Ford configurations differ by year and trim, the exact module location can vary widely even within the same model line.
How to locate the exact Park Assist module on your Ford
To determine the precise mounting location for your specific model and year, use these steps as a practical guide.
- Consult the vehicle’s factory service manual or electrical schematic for the Park Assist system to identify the module’s exact location for your model/year.
- Safely access the rear bumper area by removing the lower splash shield or inner liner to reveal the bumper interior where the module is commonly mounted.
- Inspect the left or right side of the bumper’s inner frame for a small rectangular ECU-like unit secured with a mounting bolt or bracket. Use a flashlight to help visibility.
- If you don’t find the module behind the bumper, check inside the rear cargo area near the spare tire well or behind interior trim panels, as some layouts place the module there.
- Trace the sensor wiring harness from the bumper sensors; the module is typically located along the harness route and may be attached to a metal bracket or plastic mounting point.
Accessing the module may require bumper removal or interior trim work. If you’re unsure, seek professional assistance to avoid damaging sensors or electrical connectors.
Model-specific notes
Ford’s Park Assist installations vary. For example, some mid-2010s Ford SUVs and pickups mount the control module behind the rear bumper on the passenger side, while newer crossovers may place it closer to the left wheel well. Always verify with model-year documentation or Ford’s official repair information for your exact placement.
Safety tip: When working around the bumper area, disconnect the negative battery terminal to minimize risk of short circuits, and avoid triggering parking sensors during handling.
Summary
In short, Ford parking aid modules are typically found behind or inside the rear bumper assembly, near a wheel well, with placements that vary by model and year. For the precise location on your vehicle, consult the official manual or repair diagrams, inspect the bumper area, and when in doubt, rely on a Ford dealer or qualified technician for service.
