Where is the tail light fuse on a 2008 Ford F-250?

The tail light fuse on a 2008 Ford F-250 is typically located in the vehicle’s fuse boxes, usually the engine‑compartment Power Distribution Box. If you don’t find it there, check the interior fuse panel as well. The fuse will be labeled something like "TAIL LAMP" or "TAIL/STOP" on the diagram inside the box.

Primary location: Engine compartment Power Distribution Box

Check the engine bay first, as many Ford trucks route tail lamp circuits through the Power Distribution Box. The following steps will guide you to the correct fuse and help you verify it.

• Open the hood and locate the Power Distribution Box, a large black plastic fuse box in the engine compartment.


• Remove the cover and read the fuse diagram on the underside or inside the cover to identify the fuse labeled "TAIL LAMP" or "TAIL/STOP."


• Carefully pull the identified fuse with a fuse puller or needle‑nose pliers and inspect for a blown element (the metal wire inside will be broken or visually burnt).


• If the fuse is blown, replace it with a fuse of the same amperage rating and reinstall the cover securely.

If you locate the fuse and it appears intact, the problem could lie elsewhere in the tail‑light circuit, such as the socket, wiring, or bulbs.

Secondary location: Interior fuse panel

Some configurations also place tail light protection in the interior fuse box. Look for a second fuse box inside the cab that contains lighting fuses. The cover will have a diagram indicating the relevant fuse name.

• Find the interior fuse panel, typically located under the dash on the driver’s side or behind a panel in the left kick area.


• Check the diagram to identify the fuse labeled "TAIL LAMP," "TAIL," or "TAIL/STOP."


• Remove and inspect the fuse as described above; replace only with the same amperage rating.

Remember to recheck the covers’ diagrams whenever you’re looking for a specific fuse, as labels can vary by exact trim and production week.

What to do if the fuse keeps blowing

If a tail light fuse continues to blow after replacement, there may be a short to ground, damaged wiring, or a faulty taillight socket. Take these steps to diagnose safely.

• Turn off the ignition and remove the key; disconnect the battery if you’re going to probe wiring closely.


• Inspect the taillight sockets and wiring for corrosion, exposed wires, or pinched insulation.


• Check the continuity of the tail light circuit with a multimeter to identify a short to ground or a short to power.


• Replace any burned or damaged wiring harness sections and ensure the bulbs are properly seated and the correct wattage.

If you’re not comfortable performing electrical diagnostics, or if the fuse continues to blow after these checks, consult a qualified automotive technician.

Summary

For a 2008 Ford F-250, start with the engine compartment Power Distribution Box to locate the tail light fuse (look for "TAIL LAMP" or "TAIL/STOP" on the diagram). If not found there, check the interior fuse panel inside the cabin as a secondary source. Replace any blown fuses with the same amp rating, and investigate sockets, wiring, or shorts if the fuse keeps failing.

Where is the tail light fuse on a 2008 Ford F250?

The 2008 Ford F-250 tail light fuse is located in the interior fuse panel on the driver's side, under the dashboard. The fuse is labeled "Tail Lamps" or "Marker Lamps" and is typically a 10-15 amp fuse.
 
This video shows the location of the fuse box in a Ford F250: 58sDimasCarTechYouTube · Oct 14, 2022

• Location: Interior fuse panel, under the dashboard on the driver's side. 
• Fuse label: "Tail Lamps" or "Marker Lamps". 
• Fuse rating: 10-15 amps. 
• Troubleshooting: Check the fuse for a break in the metal band. If it's blown, replace it with a new one of the same amperage. If the problem continues, also check the wiring harness for damage or corrosion. 

Which fuse controls the tail lights?

The tail light fuse is often located in a fuse box inside the cabin near the dashboard or under the hood, and its exact position and label vary by vehicle make and model. You can find the precise location by checking the owner's manual or the diagram on the fuse box cover. For example, it could be fuse #6 in the interior fuse block of a GMC Sierra or fuses #28 and #29 in the under-hood fuse box of a newer Chevy Silverado. 
You can watch this video to see how to find the tail light fuse in a Dodge Challenger: 1mElectrical Car Repair LIVEYouTube · Sep 20, 2022
How to find the tail light fuse

1. Locate the fuse boxes: There are typically two main fuse boxes. One is under the hood, and the other is inside the vehicle, often on the driver's side of the dashboard. 
2. Consult the diagram: Find the diagram on the fuse box cover or in your vehicle's owner's manual to identify the specific fuse for the tail lights. 
3. Identify the fuse: The fuse may be labeled "Tail Lamps," "Parking Lights," "Marker Lights," or "Small Lights". 
4. Remove the fuse: Use a fuse puller to safely remove the fuse without damaging it. Never use your fingers, as it can be difficult to get a good grip. 
5. Inspect the fuse: Look at the metal band inside the fuse. If the band is broken or melted, the fuse is blown and needs to be replaced with a new one of the same amperage. 
6. Replace the fuse: If the fuse is blown, install a new one with the correct amperage. You can test the new fuse by turning on the headlights; you should see a clicking sound from the relay if it's working correctly. 

This video shows how to find the tail light fuse in a GMC Sierra: 34sElectrical Car Repair LIVEYouTube · Nov 8, 2023

Where is the fuse box on a 2008 F250?

Box you have a latch right here. And there's your fuses. On this one it only shows numbers. If you know which ones for which comment below to close it you have to line up the back.

Where is the tail light fuse on a 2006 Ford F250?

The 2006 Ford F-250 tail light fuse is likely Fuse #8, a 15-amp fuse located in the under-hood fuse box, according to JustAnswer users and other Ford forums. You can also check the interior fuse panel for a fuse labeled "Exterior Lights" or similar, and it's important to use a fuse puller to safely remove the fuse, says CarParts.com.
 
You can watch this video to see how to find the fuse box and check the fuse for the brake light switch: 56sLehewYouTube · Jun 24, 2020
Location

• Under the hood: Check the fuse box under the hood for Fuse #8 (15-amp). 
• Inside the cabin: Look for the interior fuse panel, which is often on the driver's side under the dashboard. 

How to check

1. Locate the correct fuse: Use the fuse panel diagram on the inside of the fuse box lid or your owner's manual to find the fuse for the tail lights or exterior lights. It may be labeled as "Tail Lamps," "Marker Lamps," or "#8". 
2. Remove the fuse: Use a fuse puller (often provided in the fuse box) to safely remove the fuse from its slot. 
3. Inspect the fuse: A blown fuse will have a broken or burned-out metal filament inside. A good fuse will have an intact U-shaped wire. 
4. Replace if necessary: If the fuse is blown, replace it with a new one of the exact same amperage. Using a fuse with a higher amperage can cause electrical damage or a fire.