Are there any recalls on a 2008 Toyota Sequoia?

Yes. There have been recall campaigns affecting some 2008 Toyota Sequoia models, and whether your specific vehicle is affected depends on its VIN. To know for sure, check official recall databases and contact a Toyota dealer for guidance.

Safety recall campaigns are issued when the National Highway Traffic Safety Administration (NHTSA) and manufacturers identify conditions that could affect vehicle safety or regulatory compliance. The only definitive way to know if a given 2008 Sequoia has any open recalls is to look up the vehicle by its VIN and review the remedy details provided by Toyota and NHTSA.

How to check if a 2008 Sequoia has recalls

Use these steps to verify recalls for your vehicle by VIN.

• Locate your VIN (a 17-character code) on the driver-side dash near the windshield or on the driver’s door jamb.


• Visit the NHTSA recall database and enter your VIN to see open recalls, completed campaigns, and remedy instructions.


• Check Toyota’s official recall lookup page and enter your VIN for model-specific campaigns and service details.


• Contact your local Toyota dealer or an authorized service center with your VIN to confirm open recalls and schedule a free repair if needed.


• If you’re buying a used 2008 Sequoia, request a recall history report or have the VIN checked at a dealer or NHTSA to ensure there are no outstanding campaigns.

Knowing the exact recall status for your vehicle can prevent safety issues and ensure necessary repairs are completed.

Where recalls come from and what to expect

Recall campaigns originate from safety investigations and manufacturer reviews coordinated with NHTSA. Repairs are typically performed at no cost to the owner and may involve parts replacement, software updates, or safety inspections performed at an authorized dealership.

Common recall categories affecting older Toyota SUVs

Over the years, campaigns have covered a range of systems. While not every Sequoia is affected, owners of older model years have encountered recalls in several broad areas.

• Airbag inflator safety and related sensor or seat occupancy concerns


• Fuel system components (such as pumps or lines) that could cause stalling or fire risk


• Electrical systems and wiring harness safety, including attention to switches and connectors


• Steering and suspension components with potential safety implications


• Brake system issues and related sensors or controls

These categories illustrate the kinds of campaigns historically seen on older Toyota trucks and SUVs, including the Sequoia, though the exact applicability depends on the VIN and production timeline.

What to do if you find an open recall

If you discover an open recall on your 2008 Sequoia, take prompt action to have it repaired. Here are recommended steps:

• Schedule a complimentary recall repair with an authorized Toyota dealer, even if the vehicle seems fine.


• Bring your VIN and recall notice (if available) so the service advisor can identify the exact campaigns and remedies.


• Ask about repair timelines and whether temporary measures are advised before the service appointment.


• Keep copies of recall notices and repair documentation for your records and future resale.

Open recalls are safety-critical and are typically prioritized by manufacturers and regulators. Most recalls are repaired at no cost to the owner.

Summary

For a 2008 Toyota Sequoia, recalls do exist, but whether they affect your vehicle depends on its VIN. To determine your specific status, check the NHTSA recall database and Toyota’s recall lookup with your VIN, then contact a dealer to arrange any necessary, free repairs. Staying informed and acting promptly helps maintain safety and resale value.

Key takeaway

Always verify recalls by VIN and schedule repairs through an authorized dealer if any open campaigns are listed.

How much is a 2008 Toyota Sequoia worth?

The value of a 2008 Toyota Sequoia varies significantly, but it generally ranges from roughly $5,000 to over $15,000, depending on trim, mileage, condition, and options. For a standard, high-mileage, average-condition model, the trade-in value may be around $3,348, while a clean private party sale could be around $6,021. Used listings show a wide price spread, from low-end vehicles for under $8,000 to models with lower mileage listed for over $15,000.
 
Factors that influence value

• Mileage: Lower mileage significantly increases the value. For example, a model with 110,000 miles is considered low and commands a higher price than one with over 200,000 miles. 
• Condition: A vehicle's condition is crucial. A well-maintained, rust-free SUV in good shape will be worth more than one with damage or frame issues. 
• Trim level: The trim level affects value. The SR5 is the base model, while the Limited and Platinum trims are higher-end and more expensive. 
• Options: Additional options, such as four-wheel drive, will increase the vehicle's worth. 

Estimated value by scenario

• Trade-in: Around $3,348 for a clean, base model with average mileage and no options. 
• Private party sale: Around $6,021 for a clean, base model with average mileage and no options. 
• Used listings: A broad range from under $8,000 for high-mileage models to over $15,000 for lower-mileage or higher-trim options. 

How to get an exact value
To get a precise estimate for a specific vehicle, use online appraisal tools from sites like Edmunds, Kelley Blue Book, or CarMax. These services consider specific factors like the vehicle's condition, mileage, and options to provide a more accurate valuation.

What are the bad years to avoid Toyota Sequoia?

The Toyota Sequoia years to avoid are primarily the early models, specifically 2001-2008, due to issues like engine, brake, steering, and rust problems. However, 2008-2010 also had specific concerns with the accelerator pedal, and newer models from 2022 and beyond have reports of issues with the twin-turbo V6 engine, according to this YouTube video. 
This video discusses common problems in Toyota Sequoia models: 55sThe Car Care NutYouTube · Jan 3, 2024
Early generations (2001–2008) 

• 2001–2008: These years are prone to several mechanical and structural issues, including rust, frame degradation, engine problems, and brake defects. 
• 2002: This year is frequently cited as particularly problematic due to a high volume of complaints. 
• 2003: Affected by a recall for the Vehicle Stability Control system and had ball joint defects. 
• 2008: The first model year of the second generation, it had early transmission concerns and was part of an accelerator pedal recall. 

Later models (2008–2010 and 2022+) 

• 2008–2010: These models had an accelerator pedal recall due to a possible friction-related issue. 
• 2008–2010: Several Sequoias from these years had secondary air injection system issues caused by a disintegrating foam filter. 
• 2022 and newer: Reports suggest potential problems with the new twin-turbo V6 engine that replaced the V8, leading some buyers to prefer older V8 models. 

Other years and considerations

• 2004-2010: Be cautious of rust issues affecting the frame and suspension, especially in models used in areas with road salt. 
• 2001-2007: While generally reliable, these models lack modern technology and safety features. 
• 2004: This year was part of the Takata Airbag recall. 

Is there a recall on the Toyota Sequoia?

Recent Toyota Sequoia recalls include a July 2025 recall for a rearview camera software issue in 2023-2025 models, which can cause the display to go blank or green during reverse. Additionally, a August 2024 recall addressed a faulty tow hitch cover that could detach and become a road hazard on 2023-2024 models. Toyota has also issued a recall for certain 2024 models due to potential tire damage during assembly and a separate recall for 2022-2024 models for potential unintended movement in neutral.
 
Recalls by issue and model year

• Rearview camera software (2023-2025 models): A noncompliance recall was issued for a software issue affecting the 14-inch multimedia display. If the display goes blank, green, or black while the vehicle is in reverse, it may not meet a federal safety standard, increasing the risk of a crash. 
• Tow hitch cover (2023-2024 models): The resin tow hitch cover may detach from the rear bumper and become a road hazard. 
• Tires (2024 models): The passenger-side front and rear tires may have inner sidewall damage from assembly, which could cause a sudden loss of air pressure. 
• Unintended vehicle movement (2022-2024 models): There is a recall for a condition where the vehicle may move unexpectedly when in neutral and the brakes are not applied. 
• Spare tire chain (2023 models): A recall was issued because the steel chain used to secure the spare tire may have been insufficiently welded. 

How to check for recalls
To see if your specific vehicle is affected, you can check for open recalls by VIN on the Toyota website or the NHTSA website. 
What to do if your vehicle is affected

• Contact a dealer: Toyota dealers will perform the necessary repairs free of charge. 
• Take precautions: For the tow hitch cover recall, Toyota advises customers to remove the cover until they can get it replaced. 
• Wait for notification: Toyota will notify owners by mail, but you can also check online with your VIN. 

What problems do 2008 sequoias have?

Summary: Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2008-2022 Sequoia and 2007-2021 Tundra vehicles. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak.