How many litres of oil does a 2.4 Transit take?
About 6 litres of engine oil, typically 6.0 L when performing a full oil change with the filter replaced. This article explains the capacity for the Ford Transit’s 2.4-litre Duratorq TDCi and warns about small variations by model year and configuration.
Oil capacity basics for the 2.4 Duratorq TDCi
The Ford Transit has used several iterations of the 2.4-litre Duratorq TDCi diesel engine. While the exact capacity can vary slightly by year and variant, technicians commonly cite around 6.0 litres for a standard oil change with the filter. Always confirm the precise figure in your owner’s manual or with a Ford service agent for your specific vehicle.
Oil capacity by service scenario
To help you plan an oil service, here are typical figures technicians rely on when performing the job. The following reflects common practice for the 2.4 Transit engines, but exact amounts can differ slightly by model year and filter size.
- With oil filter replacement: approximately 6.0 L (about 6.3 quarts).
- If the filter is not replaced and only a top-up is done: around 5.5–5.8 L.
Note that these figures are guidelines. The precise capacity for your vehicle should be verified with the official service data and by checking the dipstick after refilling to ensure the oil level sits within the correct range.
Practical notes on oil grade and checking levels
Diesel engines of this era typically call for diesel-grade oil that meets Ford specifications, often around 5W-30 or 5W-40 depending on intake, climate, and model year. Use a quality oil that matches the manufacturer’s specification, and replace the oil filter at every service. After filling, run the engine, let it settle, and recheck the dipstick to confirm the level is within the marked range before driving.
Variations by model year and configuration
Oil capacity may differ slightly between early 2.4-litre Duratorq Transits and later variants, or between vehicles with different turbocharging or ancillary components. The guidance above covers the typical 2.4 Duratorq engines used in many Transits, but always consult your vehicle’s documentation or a Ford technician for your exact specification.
Conclusion
For a Ford Transit powered by the 2.4-litre Duratorq TDCi, plan on about 6.0 litres of engine oil when performing a full oil change with the filter replacement. If the filter isn’t changed or if the engine variant differs, the required amount may be slightly lower, roughly in the 5.5–6.0 litre range. Always verify with the owner’s manual and confirm the level on the dipstick after refilling.
Summary: The typical oil capacity for a 2.4 Transit is around 6 litres with a filter change. Check your exact model year’s documentation and verify the level with the dipstick after filling to ensure you’re within the correct range.
How much oil does a Ford Transit 2.4 take?
Capacities
| Variant | Item | Capacity in Litres (gallons) |
|---|---|---|
| 2.2L DuraTorq-TDCi, rear-wheel drive | Engine oil − with filter | 10.1 (2.2) |
| 2.2L DuraTorq-TDCi, rear-wheel drive | Engine oil − without filter | 9.7 (2.1) |
| 2.4L DuraTorq-TDCi | Engine oil − with filter | 8.8 (1.9) |
| 2.4L DuraTorq-TDCi | Engine oil − without filter | 8.4 (1.8) |
How many quarts of oil go in a Ford Transit van?
And we're going to drop that. In. So we're pretty much done dropping the oil in we're going to let that funnel sit so it drips in a bit. All right six quarts wipe your funnel down.
How much oil does a 2.4 L 4 cylinder engine take?
5.6 quarts (with filter).
What engine oil for Ford Transit 2.4 diesel?
5w30
If you're looking for a standard oil for a Ford Transit Custom, 5w30 meets all the requirements for efficient operation.
