How many quarts of oil does a 17 Lexus IS 300 take?
The IS 300 (2017) uses about 5.3 quarts of engine oil when performing a standard oil change with the filter included. Exact amounts can vary slightly depending on whether the filter is replaced and the draining process.
The 2017 Lexus IS 300 is powered by a 2.0-liter turbocharged inline-four. Knowing the correct oil capacity helps ensure you fill to the proper level during maintenance and avoid over- or under-filling. This article provides the official figures, plus practical guidance for performing the change correctly.
Official oil capacity for the 2.0L turbo engine
Before listing the capacity figures, note that these values assume a standard oil change with the filter replaced. Always verify with the owner’s manual or a dealership if you have a non-standard service.
- With the oil filter installed: about 5.3 quarts (approximately 5.0 liters).
- Without the oil filter: about 4.9 quarts.
These figures are the typical reference for planning an oil change on the 2017 IS 300’s 2.0L turbo engine. When in doubt, start with the higher amount and then top off carefully after checking the dipstick to reach the correct level.
What oil to use and how often to change it
Consensus for this engine is full-synthetic 0W-20 oil under normal driving conditions, though climate and operating conditions can justify alternative viscosities per the owner’s manual. A typical oil-change interval with synthetic oil is about every 10,000 miles (or 12 months), but aggressive driving, hot climates, or severe service may warrant shorter intervals. Always use the oil grade and capacity recommended by Lexus for your vehicle’s year and market.
When selecting oil, use products that meet or exceed Toyota/Lexus standards and ensure the oil filter is compatible with the engine. If you have a specific service history or have recently performed a non-standard repair, confirm the capacity and requirements with official documentation or a Lexus service center.
How to verify the oil fill level after a change
After adding oil, run the engine briefly, then park on level ground and allow it to cool before rechecking the dipstick. Add small increments if the level is low, and recheck until the dipstick shows the correct range. Consistently overfilling can cause engine issues, so aim for a precise fill based on the dipstick measurement.
Summary
For a 2017 Lexus IS 300, anticipate about 5.3 quarts of engine oil with the filter during a standard oil change. Use full-synthetic 0W-20 as recommended, and confirm exact capacity and specifications in the owner’s manual or with a Lexus dealer, especially if your vehicle has unique service history or operating conditions. Accurate oil capacity helps maintain engine longevity and optimal performance.
