How many quarts of oil does a 2013 Acura MDX take?
The 2013 Acura MDX with the 3.5-liter V6 engine requires about 5.7 quarts of engine oil when performing a full drain and refill with a new filter.
Capacity in numbers
The following figure reflects Acura’s standard capacity for a full oil change on the 3.5L MDX. This amount includes the new filter.
- 5.7 quarts (with filter)
Note that the exact amount can vary slightly depending on the oil filter size and drain procedure. Always check the dipstick after adding oil and before starting the engine.
Oil type and maintenance tips
Recommended oil viscosity
For most regions, Acura recommends a full-synthetic 0W-20 motor oil for the 2013 MDX. Use the correct filter and follow the manufacturer’s maintenance schedule to keep the engine in top condition.
Summary: In short, the 2013 Acura MDX requires about 5.7 quarts of engine oil when performing a full change with a new filter. Verify with your owner's manual and local dealer for exact specifications in your area.
How much oil does a 3.5 L V6 engine take?
Capacities and Specifications - 3.5L Ecoboost
| Item | Capacity |
|---|---|
| Engine oil (with oil filter) | 5.7 L (6.0 qt) |
| Engine coolant | 12.4 L (13.1 qt) |
| Brake fluid | Between MIN/MAX on brake fluid reservoir |
| Rear axle fluid (four-wheel drive) | 2.11 pt (1.0 L) |
How many quarts of oil does a 3.6 L V6 take?
A 3.6L V6 engine typically takes between 5 and 6 quarts of oil, but the exact amount varies by vehicle model, so you must check your owner's manual or the oil fill cap for the precise capacity. For example, some models like a 2013 Jeep JK require 6 quarts, while newer models like a 2020 Jeep Wrangler or 2018+ Jeep Wrangler JL may only take 5 quarts.
Here are some general guidelines:
- Check your owner's manual: This is the most reliable source for your specific vehicle.
- Look at the oil fill cap: It may have the required viscosity and capacity printed on it.
- Consider the model year: Newer vehicles, especially certain Jeep models, have different oil capacities than older ones.
- Change the oil filter: Always include an oil filter change, as this is part of the full oil capacity.
- After refilling, check the level: After you've filled the engine with oil, use the dipstick to check the oil level and add more if needed to reach the "full" line.
How much oil goes in a 2013 Acura MDX?
Oil Grade: API*
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts (with filter). After refill check oil level. |
| Capacity: | 4.2 quarts. w/of. After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. Only use an OE drain plug. |
How many quarts of oil does an Acura MDX need?
The Acura MDX oil capacity varies by model year and engine type, but most 3.5L V6 engines require around 5.7 quarts of oil with a filter, while the Type S models with a 3.0L turbocharged V6 hold about 6.0 quarts. Newer models often have slightly different capacities, such as the 2025 MDX using 5.5 quarts, so it is always best to check the owner's manual or the dipstick after an oil change.
Typical capacities by engine type
- 3.5L V6: Around 5.7 quarts (with filter)
- 3.0L Turbocharged V6 (Type S): Approximately 6.0 quarts (with filter)
- Model-specific variations: Some newer models might have slightly different capacities, like the 2025 MDX at 5.5 quarts. Older models will have different requirements, such as the 2013 model needing 4.5 quarts.
Important considerations
- Always check your owner's manual: This is the most reliable source for your specific vehicle's oil capacity.
- Check the dipstick: After filling the oil, run the engine briefly, then check the dipstick to ensure the level is correct and add more if needed.
- Replace the filter: It is essential to replace the oil filter at every oil change.
- Use the correct oil type: Always use the manufacturer-recommended oil type, such as 0W-20 for newer models, to ensure engine longevity.
