How many quarts of oil does a 2015 Chevy Traverse 3.6 L take?
The engine in the 2015 Traverse with the 3.6-liter V6 typically requires about 6 quarts of engine oil for a full change with a new filter (roughly 5.7 liters).
For readers planning maintenance, the precise amount matters when draining old oil, replacing the filter, and refilling to the correct level. The 3.6L V6 used in the 2015 Traverse generally carries a 6-quart capacity with a new filter, though variations can occur depending on the exact engine variant (LLT or LFX) and service method. This guide lays out the standard capacity and practical tips for performing a proper oil change.
Oil capacity specifics for the 3.6L V6 in the 2015 Traverse
Engine variants and notes
GM’s 3.6L V6 in this generation spans LLT and LFX variants. The commonly cited total oil capacity for a full change with a new filter is 6 quarts (about 5.7 liters). This figure is the baseline used by most owners and service guides for the 2015 model year.
Before listing the figures, note that your vehicle’s exact capacity is usually published as the total oil capacity with a filter for a full change.
- Oil capacity (with filter): 6 quarts (about 5.7 liters).
- Included with standard oil changes: 6 quarts is intended to be sufficient when replacing the oil filter.
- Variation: Some sources may quote a range depending on drain and fill methods; always confirm with the owner's manual for your exact VIN if in doubt.
Concluding: For a typical full oil change on a 2015 Traverse 3.6L V6, plan on about 6 quarts of oil, plus a new filter, to reach the proper dipstick level.
Oil type, capacity, and maintenance considerations
Recommended oil and maintenance guidelines
To keep the V6 running smoothly, use the recommended oil specification and observe standard maintenance intervals.
- Recommended oil: Dexos1 Gen 2 5W-30 synthetic (or as specified in the owner's manual) for most climates and driving conditions.
- Oil change intervals: Approximately every 7,500–10,000 miles under normal driving; adjust for severe service as advised by GM or your dealer.
- Practical steps: Always replace the oil filter during a change and upfill to the correct level after the engine has run and settled.
Concluding: Following the recommended oil type and change interval helps maintain engine health for the 3.6L V6 in the 2015 Traverse.
Summary
In summary, expect about 6 quarts of engine oil for a complete oil change with a new filter on the 2015 Traverse 3.6L V6, using Dexos1 Gen 2 5W-30 synthetic oil or equivalent, and refer to your owner's manual for any VIN-specific guidance.
How much oil do you put in a 3.6 L V6?
The oil capacity for a 3.6L V6 engine is typically 5 to 6 quarts, but it varies by vehicle model and year. For a 2020 Dodge Charger, it's around 5.9 quarts, while a 2023 Jeep Wrangler requires 5 quarts. Newer Jeeps, such as the 2016-2021 Grand Cherokee and Durango, often require 6 quarts. Always check your specific owner's manual for the most accurate information, as it can differ even within the same engine family.
- 5 quarts: Common in many models like the 2020 Jeep Wrangler and 2025 Ram 1500.
- 5.9 quarts: The capacity for some models, such as the 2020 Dodge Charger.
- 6 quarts: Required for certain vehicles, including the 2013 JK Jeep Wrangler and some 2016-2021 Grand Cherokee and Durango models.
- Check your owner's manual: This is the most reliable source for your specific vehicle's oil capacity.
- After refilling: It's important to check the oil level with the dipstick after refilling to ensure it is correct.
How much oil does a 2015 Chevy Traverse 3.6 take?
6 quarts
Oil Grade: SEOC3
| Viscosity: | 0W-30 (Below -29°C) 5W-30 (All TEMPS) |
|---|---|
| Capacity: | 6 quarts (with filter). After refill check oil level. |
| Torque: | 18 ft/lbs (Oil Drain Plug) |
| Notes: | (1) This specification has been updated from Dexos 1 Gen 2 to GM Dexos 1 Gen 3. |
What oil does a 2015 Chevy Traverse use?
The recommended oil for a 2015 Chevy Traverse is SAE 5W-30 full synthetic for most temperatures, though SAE 0W-30 full synthetic can be used in cold climates where temperatures drop below -20∘negative 20 raised to the composed with power−20∘F. You will need approximately 6 quarts of oil.
- Standard: SAE 5W-30 full synthetic
- Extreme Cold (below -20∘negative 20 raised to the composed with power−20∘F): SAE 0W-30 full synthetic
- Oil Capacity: 6 quarts (with filter change)
How much oil does a 3.6 Chevy engine hold?
A Chevy 3.6L V6 engine typically requires 6 quarts of oil when replacing the filter. The specific oil capacity can vary slightly depending on the model and year, so it's always best to confirm with your owner's manual or check the dipstick after adding the new oil.
- Standard capacity: Six quarts of oil (SAE 5W-30 is commonly recommended) for a standard oil and filter change.
- Check the dipstick: After filling with oil, start the engine to circulate the new oil and then check the dipstick to ensure the level is correct.
- Confirm with your manual: For specific capacities on other models (or in special cases like the 2022 Traverse, which has a much higher capacity listed), always consult your vehicle's owner's manual.
