How many quarts of oil does a 2017 Crosstrek take?
The 2017 Subaru Crosstrek with the standard 2.0-liter engine generally requires about 4.2 quarts of engine oil when performing a full oil change with a new filter. Exact capacity can vary slightly, so always confirm with the owner's manual and use the dipstick to ensure the oil level is correct after filling.
Oil Capacity for the 2.0L Crosstrek
Capacity can differ depending on whether the oil filter is replaced during the change. The figures below reflect the typical specification for the 2.0L engine used in the 2017 Crosstrek.
- With the oil filter replaced: about 4.2 quarts (approximately 4.0 liters).
- Without changing the oil filter: about 4.0 quarts (approximately 3.8 liters).
In practice, start with roughly 4.2 quarts, then check the dipstick and top off as needed to reach the full mark.
Recommended oil type and viscosity
Subaru generally recommends 0W-20 synthetic oil for the 2.0L engine in most climates. Always consult the owner's manual for the exact specification and any regional variations that may apply to your vehicle.
How to check and maintain oil level
Regularly checking and maintaining the correct oil level helps protect the engine and ensures optimal performance. Follow these steps during an oil change or routine check:
- Park on level ground and gently warm the engine to operating temperature (about 10 minutes of idle or light driving).
- Shut off the engine and wait a few minutes for the oil to settle.
- Remove the dipstick, wipe it clean, reinsert fully, then remove to check the level against the full and low marks.
- If the level is low, add oil in small increments (about 0.25–0.5 quart) and recheck until you reach the full mark.
- Replace the dipstick and the oil filler cap securely; start the engine and check for leaks after several minutes of idle.
Overfilling can cause engine damage, so proceed with small additions and recheck carefully.
Summary
For a 2017 Crosstrek with the 2.0-liter engine, plan for about 4.2 quarts of engine oil per oil change when replacing the filter. The total can be about 4.0 quarts if the filter is not replaced. Use 0W-20 synthetic oil as the default recommendation, and always verify specific requirements in the owner's manual. Regularly check the dipstick after fills and avoid overfilling.
