How many quarts of oil does a Toyota Highlander V6 take?
Most Highlander V6 models take about 6 quarts of engine oil with a filter; older V6 variants use roughly 4.5 to 5.5 quarts. Always verify the exact amount for your year and engine in the owner's manual.
Engine variants and oil capacities
The Highlander has used several V6 engines over its lifetime, and oil capacity varies by engine family and model year. The figures below reflect typical capacities when performing a standard oil change with a new filter.
- 3.5L V6 (2GR-FE/2GR-FKS) — roughly 6.0 quarts (with filter).
- 3.0L V6 (1MZ-FE) — roughly 4.5–4.8 quarts (with filter).
- 3.3L V6 (3MZ-FE) — roughly 5.0–5.5 quarts (with filter).
These ranges cover a broad span of model years, from the early 2000s through the mid-2010s and later. Exact capacity can vary by trim, transmission, and whether the vehicle uses synthetic oil or has any special factory supplements. Always refer to the exact specification for your vehicle.
How to confirm the exact capacity for your vehicle
To avoid guessing, verify the precise data for your Highlander using official sources and in-vehicle labeling.
- Check the owner's manual section on oil capacity and recommended oil type.
- Look for an under-hood sticker that lists oil capacity and viscosity requirements.
- Consult Toyota’s official service data or a trusted database using your VIN for the exact figure.
Note: If you use a different oil viscosity or a nonstandard oil change interval, capacity figures can be slightly affected by OEM recommendations.
Maintenance reminders
Before performing an oil change, gather the right oil type, a new filter, and the appropriate tools. If you switch to synthetic oil, consult the manual for potential interval extensions and any manufacturer cautions.
Summary: The Toyota Highlander’s V6 oil capacity depends on the engine family. The 3.5L V6 commonly uses about 6 quarts with a filter, while older 3.0L and 3.3L V6 engines use roughly 4.5–5.5 quarts. For the exact figure, always check the owner's manual or official Toyota service data for your year and VIN.
How much oil does a 3.5 L V6 Toyota engine take?
6.1 quarts
3.5L V6 Engine: 6.1 quarts with filter. 2.5L Hybrid Engine: 4.5 quarts with filter.
How much oil does a 3.5 L V6 take?
The oil capacity for a 3.5L V6 engine is typically 6 to 6.1 quarts when changing the oil and filter, though it can vary by vehicle model. For specific capacities, always consult your vehicle's owner's manual or use a lookup tool for your make and model, as different engines have different requirements.
- Toyota engines often use about 6.1 quarts with a filter change, notes this Capistrano Valley Toyota page and this Reddit post.
- Ford EcoBoost 3.5L engines commonly require 6.0 quarts with a filter change, say AMSOIL and Holman Ford Turnersville.
- Other 3.5L V6 engines, such as those found in older models like a 2008 Chevrolet Impala, may use less, with that specific model requiring 4 quarts.
How much oil does a 3.5 L V6 Toyota Highlander take?
The oil capacity for a Toyota Highlander with a 3.5L V6 engine is 5.8 quarts for models without the towing prep package, and 6.4 quarts for models that include the towing prep package with an additional oil cooler. Always use the oil specified in your owner's manual, which is typically SAE 0W-20 for this engine.
Oil capacity by model
- Standard 3.5L V6 engine: 5.8 quarts
- 3.5L V6 engine with towing prep package: 6.4 quarts
Important considerations
- Oil type: The recommended oil viscosity is SAE 0W-20. If it's unavailable, you can use 5W-20 temporarily, but you must switch back to 0W-20 at the next oil change.
- Check the dipstick: After refilling, check the oil level with the dipstick and add more oil as needed to reach the full mark.
- Oil filter: Always change the oil filter when you change the oil. The capacity figures listed above are for when the filter is replaced.
How many quarts of oil does a 2019 Toyota Highlander V6 take?
The 2019 Toyota Highlander V6 requires 5.8 quarts of SAE 0W-20 oil with a filter change. It is important to check the dipstick after refilling, starting with a slightly lower amount, to ensure the correct level is reached.
- Oil Capacity: 5.8 quarts with filter
- Oil Type: SAE 0W-20 is recommended
- After Refill: Check the dipstick and add oil as needed to reach the correct level
