How many quarts of transmission fluid does a 1993 Ford F-150 take?

The fluid capacity depends on the automatic transmission installed. In general, about 11–12 quarts are needed for the AOD, while around 15 quarts are needed for the E4OD. Exact figures can vary with pan drops, filter changes, and whether you perform a full flush. Always verify the capacity for your specific VIN and transmission code.

Transmission options in the 1993 F-150

The 1993 F-150 used a couple of automatic transmissions depending on engine and trim. The two most common are listed here with their rough capacities:

• AOD (Automatic Overdrive) — total capacity roughly 11–12 quarts.


• E4OD (Electronic 4-Speed Overdrive) — total capacity roughly 15 quarts.

The figures above refer to a standard drain-and-fill with a pan drop. A full flush or replacement of the pan gasket and filter can require a little more fluid.

How to identify your exact transmission and capacity

To determine the precise amount for your truck, identify the transmission model and consult the official capacity guidelines for that unit.

1. Check the transmission model code stamped on the housing or on a tag near the dipstick area (common codes for this era are AOD and E4OD).


2. Refer to the Ford Shop Manual or a trusted repair manual (e.g., Haynes, Chilton) for the official fluid capacity for that model.


3. When performing service, consider the method (pan drop vs. flush) and have a little extra fluid on hand to account for the torque converter and cooler lines.

Bottom line: Plan around 11–12 quarts for AOD-equipped trucks and about 15 quarts for E4OD-equipped trucks, with slight adjustments based on your service method and components.

Summary

The 1993 Ford F-150 does not have a single universal transmission fluid capacity. The typical total fill ranges from about 11–12 quarts for AOD-equipped models to around 15 quarts for E4OD-equipped models. Confirm the exact capacity using your VIN, transmission code, and the official service manual, especially if performing a full flush or replacing the pan gasket and filter.

How much fluid does a e4od transmission hold?

The E4OD transmission fluid capacity is approximately 16 to 18 quarts for a full refill with the pan and torque converter drained, but can vary. A simple pan drop and filter change requires a smaller amount, around 6 to 8 quarts. It is crucial to always check the fluid level with the engine running and warmed up after the refill, following the correct procedure for your vehicle. 
E4OD transmission fluid capacity

• Full refill (pan and torque converter drained): Around 16 to 18 quarts. 
• Pan drop and filter change only: Approximately 6 to 8 quarts. 
• Aftermarket cooler: You may need slightly more if you have an aftermarket transmission cooler. 

Important tips

• Check the fluid level correctly: After adding fluid, start the engine, let it warm up, and check the dipstick with the engine in park. 
• Don't overfill: Overfilling can cause foaming and lead to shifting problems. 
• Use the correct fluid: Ford has updated its recommendation from Mercon to Mercon V for some E4OD transmissions. Always verify the correct fluid type for your specific vehicle. 

How many quarts of transmission fluid does my Ford F-150 take?

The automatic transmission fluid capacity for a Ford F-150 varies by model and transmission type, ranging from about 13 to 14 quarts for a total fill and approximately 6 to 8 quarts for a pan drop and filter change. Always check your owner's manual for the specific capacity and fluid type for your year, model, and engine. 
Approximate fluid capacities

• Total fill: Around 13 to 14 quarts. 
• Pan drop and filter change: Around 6 to 8 quarts, as a significant amount of fluid remains in the torque converter. 

Important considerations

• Fluid type: Always use the type of automatic transmission fluid (ATF) specified by Ford for your vehicle. Some models may require MERCON LV. 
• Checking the level: Use the dipstick to check the level once the transmission is at the correct operating temperature (typically around 100°F100 °F100°F). 
• Overfilling: Be careful not to overfill the transmission, as this can cause damage and shifting issues. 
• Filter replacement: If you are replacing the filter, it is best to perform a full fluid exchange afterward, or multiple fluid changes to remove as much old fluid as possible. 

How many quarts of transmission fluid does a 47RE take?

The 47RE transmission has a total capacity of approximately 14.8 to 16.9 quarts (14-16 liters), while a typical service fill is around 4 to 6 quarts. To properly fill the transmission, add the initial 6 quarts, then start the engine, and add the remaining 7 to 8 quarts in increments while checking the fluid level with the engine running and the transmission in neutral, as per Goerend Transmission. 
47RE transmission oil capacity

• Total capacity: 14.8–16.9 quarts (14–16 liters) 
• Service fill capacity: Around 4–6 quarts for a basic fluid change 

How to fill the transmission

1. Add initial fluid: Pour about 6 quarts of transmission fluid into the dipstick tube.
2. Start the vehicle: Turn the engine on and let it run for a short while.
3. Add more fluid: Add another 7 to 8 quarts of fluid through the dipstick tube.
4. Check the level: With the engine running and the transmission in neutral, check the fluid level. Read the dipstick from the low side.
5. Top off: Add fluid until it reaches the full mark.
6. Final check: Drive the vehicle for 5–10 miles and recheck the fluid level one last time. 

How much transmission fluid does a 1993 Ford f150 hold?

A 1993 Ford F-150 with an automatic transmission typically requires about 6–7 quarts for a fluid and filter change, with a total capacity of around 12–14 quarts depending on the specific transmission (like the E4OD or C6). A manual transmission capacity will vary, with some around 3.5 pints to 7.6 pints. Always verify your truck's specific transmission type and consult the owner's manual or a reliable service guide for the most accurate capacity. 
You can watch this video to learn how to service an automatic transmission on a 1993 F-150: 58sLow Tech GarageYouTube · Dec 31, 2020

• Automatic Transmission (drain and refill): Approximately 6–7 quarts. 
• Automatic Transmission (with filter and full capacity): Varies by model, but expect around 12–14 quarts. For example, the E4OD has a total capacity of about 15.7 quarts and an initial fill of 6.4 quarts. 
• Manual Transmission: Capacity varies by model, with some ranging from about 3.5 to 7.6 pints. 
• Fluid type: For automatics, use MERCON or MERCON V fluid, and for manuals, check your specific requirements. 

Important: 

• Always check the fluid level with the dipstick when the engine is warm and running in park or neutral.
• Refer to a repair manual or service guide to confirm your specific transmission model and its exact fluid capacity and type before starting service.