Loading

How many quarts of transmission fluid does a 2007 Chevy Colorado take?

For the 2007 Colorado, the automatic transmission typically holds about 13–14 quarts of fluid in total, and a standard drain-and-fill replaces roughly 7–9 quarts. A manual transmission version generally requires about 2.5–3 quarts of gear oil. Always verify the exact figure in your owner’s or service manual for your specific configuration.


Transmission options in the 2007 Colorado


The Colorado offered two primary transmission setups in 2007: an automatic 4L60-E and a manual NV-series gearbox (NV1500 or NV3500, depending on engine and trim). Capacity figures vary slightly depending on the model, whether you drain the torque converter, and whether you replace the filter or pan gasket during service.


Automatic transmission capacity


Below are the commonly cited figures for the automatic transmission used in many 2007 Colorados. These numbers can vary slightly by model year, equipment, and service method.



  • Total system capacity (including the torque converter): about 13–14 quarts

  • Pan capacity (fluid in the pan when fully drained): roughly 4–5 quarts

  • Drain-and-fill quantity (typical pan drop with filter change, not draining the torque converter): about 7–9 quarts

  • Recommended fluid type: Dexron VI (fully compatible with older Dexron III; confirm with your manual)

  • Level-check guidance: after warming up the transmission, cycle through gears, then recheck the level on level ground and follow the manual’s procedure


Conclusion: Use the service method that matches your repair (pan drop, filter change, and whether you drain the torque converter) and always verify level via the dipstick per the manual.


Manual transmission capacity


The manual transmissions offered in the 2007 Colorado (such as the NV1500 or NV3500) take significantly less fluid than the automatic. Exact capacity depends on the model, but it lies in a narrow range.



  • Estimated capacity: about 2.5–3.0 quarts of gear oil

  • Recommended oil type: GL-4 or GL-5 gear oil, typically 75W-90

  • Fill guidance: fill through the transmission fill plug until fluid starts to seep from the fill opening, then reinstall and verify level when the transmission is up to temperature


Conclusion: Plan for roughly 2.5–3 quarts when servicing the manual transmission, and always consult the specific manual for your NV1500 vs NV3500 configuration to confirm exact capacity.


Practical tips for filling and checking levels


Correct transmission fluid quantity matters for performance and longevity. Always use the fluid type recommended by GM for your transmission, confirm the exact capacity in your vehicle’s manual, and perform a level check with the transmission at operating temperature on level ground. If you recently performed a full pan and filter service on the automatic, anticipate needing closer to the higher end of the typical 7–9 quart refill, whereas a simple drain-and-fill will require less.


Summary


The 2007 Chevy Colorado’s transmission fluid capacity depends on the transmission type. Automatics (4L60-E) typically require about 13–14 quarts in total, with a drain-and-fill often around 7–9 quarts, using Dexron VI. Manuals (NV1500/NV3500) use roughly 2.5–3 quarts of gear oil. Always verify exact figures in the owner’s or service manual and follow the proper fill and level-check procedures to ensure proper operation.

How much transmission fluid does a 2008 Chevy Colorado hold?


For Automatic Transmission: 4L60-E....AF6

Capacity:4 speed 4L60-E Total Fill 11.2 quarts.
Capacity:5 quarts Initial Fill.



What kind of transmission fluid goes in a 2007 Chevy Colorado?


Valvoline DEXRON VI/MERCON LV Automatic Transmission Fluid 1 Quart.



How many quarts of transmission fluid does a Chevy Colorado take?


The amount of transmission fluid a Chevy Colorado needs depends on the year, model, and transmission type, ranging from around 6.76.76.7 quarts for an initial fill on some models to over 111111 quarts for a full system capacity on others. For example, a 2021 2.8L diesel with a 6-speed transmission needs a full fill of 11.211.211.2 quarts, while a 2007 model with a 4-speed 4L60-E transmission has a total fill capacity of 11.211.211.2 quarts as well. You should always check your owner's manual for the exact specification for your vehicle. 

  • Full system capacity: This can be around 11.211.211.2 to 11.411.411.4 quarts for many automatic transmissions, depending on the model and year. 
  • Initial fill: For a standard drain and fill, the amount needed will be significantly less than the total capacity. For example, a 2021 2.8L diesel with a 6-speed transmission requires an initial fill of 6.76.76.7 quarts. 
  • Manual transmission: For a 2006 model with a 3.5L engine, the manual transmission capacity is 4.94.94.9 pints, which is less than 333 quarts. 
  • Check your owner's manual: The most accurate information for your specific vehicle is in the owner's manual. 



How much transmission fluid does a 2007 Chevy Colorado take?


Automatic Transmission Fluid
Capacity: 4 speed 4L60-E Total Fill 11.2 quarts.


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.