How many quarts of transmission fluid does a 2008 Dodge RAM 1500 take?
The 2008 Dodge RAM 1500 requires approximately 6 quarts of transmission fluid to fill the transmission. This is the standard amount needed for this specific model and year of the Dodge RAM 1500 pickup truck.
Detailed Explanation
The 2008 Dodge RAM 1500 is equipped with a 5-speed automatic transmission. The transmission fluid capacity for this model is typically around 6 quarts, though the exact amount may vary slightly depending on the specific configuration of the vehicle.
To properly service the transmission, it's important to use the correct type and amount of fluid. Using the wrong fluid or an incorrect quantity can lead to transmission problems down the road. The recommended transmission fluid for a 2008 Dodge RAM 1500 is typically a Mopar-approved ATF+4 fluid.
Transmission Fluid Change Procedure
Changing the transmission fluid in a 2008 Dodge RAM 1500 involves the following steps:
- Park the vehicle on a level surface and apply the parking brake.
- Locate the transmission fluid drain plug, usually located at the bottom of the transmission case.
- Place a drain pan underneath and remove the drain plug to allow the old fluid to drain out.
- Once the fluid has fully drained, replace the drain plug and tighten it securely.
- Locate the transmission fluid fill plug, usually on the side of the transmission case.
- Using a fluid transfer pump, slowly add new transmission fluid through the fill plug until it begins to drip out.
- Replace the fill plug and tighten it securely.
- Start the engine and let it idle for a few minutes to circulate the new fluid.
- Check the fluid level and add more if necessary to bring it up to the proper level.
It's important to consult your owner's manual or a professional mechanic for the specific fluid capacity and change interval recommended for your 2008 Dodge RAM 1500.
How much transmission fluid does a 2008 Dodge Ram 2500 68RFE hold?
Ram 68RFE Cummins Diesel Transmission Fluid Capacity Notes
The diesel application has a total dry transmission fluid fill capacity of 17.5 quarts or 16.5 liters.
How much transmission fluid does a 2008 Dodge RAM 1500 hold?
Automatic Transmission Fluid
4 speed 42RLE Total Fill 8.8 quarts.
How much to change transmission fluid on RAM 1500?
The average cost for a Dodge Ram 1500 Transmission Fluid Change is between $183 and $211 but can vary from car to car.
How many quarts of transmission fluid do I need for a change?
Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.
How often should Ram 1500 transmission fluid be changed?
60,000 Miles
60,000 Miles: The transmission fluid, filters, engine coolant, and brake fluid should be checked and replaced as needed. 100,000 Miles: In addition to repeating many of the services above, you'll also need to have your spark plugs and wires and PVC joints inspected and replaced.
How many quarts does a RAM 1500 hold?
Typically, RAM 1500 trucks take six quarts during an oil change. However, you should fill the HEMI with seven because of the engine's size difference.
How much transmission fluid does a Dodge RAM 1500 hold?
6 liters of synthetic automatic transmission fluid (ATF) specifically developed and engineered for 8-speed transmissions used in the Ram 1500.
How much does it take to change transmission fluid?
The cost of a transmission fluid change, typically ranging from $100.00 to $300.00, is tied to the specific fluid required by the vehicle. Quality, brand, and quantity contribute more to the cost than labor.
Is 4 quarts of transmission fluid enough?
You might need 3 to 5 quarts of fluid for a standard automatic transmission car. -Suvs or trucks may need 5 to 7 quarts or more. You'll need less for manual transmissions, about 2 to 4 quarts. Transmission, such as standard or CVT, also affects the kind and quantity of fluid.
Do you leave the car running when adding transmission fluid?
Your car's engine should be running when you add fluid to the transmission, but you should have the transmission in park and the handbrake activated for safety. Check the owner's manual for instructions on selecting the correct transmission fluid for your vehicle.
