How many quarts of transmission fluid does a 2011 Dodge Avenger take?
The typical total transmission fluid capacity for a 2011 Dodge Avenger is about 11 quarts for a standard pan drain and fill, and around 13 quarts if you perform a complete fluid replacement that includes the torque converter and cooler lines. Exact amounts depend on the specific transmission variant and service procedure.
This article explains the standard capacities, how service type affects the quantity, and practical tips to ensure you add the correct amount for your vehicle.
Typical capacities by service type
Before listing the figures, note that service type matters. A simple drain-and-fill uses less fluid than a full replacement that circulates or drains fluid from the torque converter and lines.
- Pan drain and fill (with filter): about 11 quarts of ATF are typically required to complete the service.
- Full transmission replacement (including torque converter and cooling lines): roughly 13 quarts or a bit more may be needed to refresh all of the fluid in the system.
These values are general guidelines. The exact capacity can vary by transmission code and factory-filled configuration, so consult your owner's manual or a service bulletin for your VIN.
Practical considerations for checking and filling
When you perform a fill, follow the manufacturer's procedure for checking the transmission fluid level. After warming the car and running through a few gear shifts, check the dipstick and add small amounts as needed to reach the correct level; avoid overfilling, which can cause foaming and transmission damage.
ATF specification
Chrysler-group vehicles from that era typically use ATF+4. Always confirm the correct fluid specification for your transmission by checking the owner's manual or a service bulletin.
Summary
For most 2011 Dodge Avengers, plan on about 11 quarts for a standard drain-and-fill and around 13 quarts for a full replacement. Exact amounts depend on the transmission variant and service method, so verify with the owner's manual or a trusted service document for your VIN.
Bottom line: start with roughly 11 quarts for a basic service, and be prepared to top up toward 13 quarts if you’re flushing and replacing all fluid. When in doubt, consult the official manual or a qualified technician to avoid under- or over-filling.
How many quarts of transmission fluid does a Dodge Avenger take?
For Automatic Transmission: 62TE....AP4
| Capacity: | 6 speed 62TE Total Fill 9 quarts. |
|---|---|
| Capacity: | 5.5 quarts Initial Fill. |
How many quarts are needed for a transmission fluid change?
Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.
How many quarts of transmission fluid does a 2011 Dodge Charger take?
Automatic Transmission Fluid
Capacity: 5 speed NAG1 Total Fill 8.1 quarts. Capacity: 5.3 quarts Initial Fill.
How many quarts does a 2011 Dodge Avenger take?
4.5 quarts
