How many quarts of transmission fluid does a 2011 Ford Edge take?
Approximately 12 quarts of Dexron VI automatic transmission fluid are typically required for a full transmission service on the 2011 Ford Edge (6F35), with about 5–7 quarts needed for a drain-and-fill. The exact amount can vary if the transmission filter is replaced or if your vehicle has VIN-specific equipment; always verify the fluid level after service and consult the owner's manual for your exact configuration.
Capacity considerations for the 2011 Edge
Full change vs drain-and-fill
Before listing typical quantities, note that the service method affects the amount of fluid you’ll need. The figures below reflect common practice but can vary by vehicle and configuration.
The following figures reflect common practice, but your actual numbers can vary by vehicle and service method.
- Total capacity for a complete fluid change (including the torque converter, cooler lines, and a new filter) is typically around 11–12 quarts of Dexron VI ATF.
- A straightforward drain-and-fill (without replacing the filter) typically requires about 5–7 quarts to reach the proper level.
- Use Dexron VI automatic transmission fluid as specified by Ford; avoid mixing fluids or using older Dexron variants unless Ford explicitly permits it for your VIN.
- Vehicle variations by VIN or options can affect exact quantities; always confirm with the owner's manual or a Ford service bulletin for your exact configuration.
Concluding: For a 2011 Edge, plan on roughly 12 quarts for a full change with a new filter, and about 5–7 quarts for a drain-and-fill. Always verify the level with the dipstick after service.
Summary
The 2011 Ford Edge with the 6F35 transmission generally requires about 12 quarts of Dexron VI ATF for a full fluid change with a new filter, while a drain-and-fill uses roughly 5–7 quarts. Confirm exact amounts for your VIN and service method, and check the fluid level after completion.
