How much coolant does a 2007 Dodge Charger 3.5 take?
The 2007 Dodge Charger 3.5 requires approximately 13.7 quarts (13 liters) of engine coolant to fill the cooling system. This includes the radiator, engine block, and all connecting hoses and passages. It's important to use the recommended type and quantity of coolant specified by the vehicle manufacturer to ensure proper cooling and prevent damage to the engine.
Detailed Coolant Capacity for the 2007 Dodge Charger 3.5
The 2007 Dodge Charger 3.5 has a V6 engine with a total cooling system capacity of 13.7 quarts (13 liters). This includes the following components:
- Radiator: 7.6 quarts (7.2 liters)
- Engine block: 6.1 quarts (5.8 liters)
- Hoses and other connections: Approximately 1 quart (0.9 liters)
It's crucial to use the correct type of coolant recommended by Dodge, which is typically a 50/50 mix of antifreeze and distilled water. Using the wrong coolant or an improper mix can lead to corrosion, reduced cooling efficiency, and potential engine damage.
Coolant Replacement Procedure
When replacing the coolant in a 2007 Dodge Charger 3.5, follow these steps:
- Ensure the engine is cool before beginning the process.
- Locate the radiator drain plug and drain the old coolant into a suitable container.
- Once the radiator is empty, remove the coolant reservoir cap and fill the system with the recommended 50/50 coolant mixture until it reaches the full mark.
- Start the engine and allow it to run until the thermostat opens, then top up the coolant level as needed.
- Dispose of the old coolant properly, as it can be harmful to the environment.
It's important to follow the manufacturer's instructions and use the correct type and quantity of coolant to maintain the health and performance of your 2007 Dodge Charger 3.5 engine.
How much coolant does a 2008 Dodge Charger 3.5 take?
Coolant
| Capacity: | 2WD11.1 quarts. |
|---|---|
| Capacity: | AWD11.4 quarts. |
How many quarts does a 2007 Dodge Charger take?
6 quarts
Capacity: 6 quarts (with filter).
How many gallons of antifreeze coolant do I need?
With some engines, the right level of this mix will require as much as two gallons of antifreeze/coolant and approximately the same amount of water. Smaller engines will typically require less coolant.
How many gallons does a 2007 Dodge Charger hold?
19 gal
Fuel & MPG
| Range in miles (city/hwy) | 285/418 mi. |
|---|---|
| Fuel tank capacity | 19 gal. |
How much coolant does a Dodge Charger 3.6 hold?
All dimensions measured at curb weight with standard tires and wheels. Oil Capacity 6.6 litres (7 qt.) Coolant Capacity 13.9 litres (14.7 qt.)
How much coolant do I need to flush my car?
Most vehicles need 1–1.5 gallons of pure coolant after flushing, check owner manual if need be.. I only use a flush for extremely corroded systems. I drain, fill with water and drive it, letting the water system flush the system for up to 1 week with a weak coolant solution. Than drain and fill as normal.
How many quarts does a V6 Dodge Charger take?
Capacity: 5.9 quarts (with filter). After refill check oil level.
How much coolant does a 2007 Dodge Charger take?
Capacity: 4 quarts Initial Fill.
What color coolant for Dodge Charger?
What color coolant does 2022 Dodge Charger use? It's critical to understand that color doesn't matter. While most Organic Acid Technology (OAT) coolants are usually orange, yellow, red or purple, Hybrid Organic Acid Technology (HOAT) coolants are orange and yellow. So evidently, there's quite a bit of overlap.
How much is a coolant flush Dodge Charger?
The average cost for a Dodge Charger Coolant Change is between $384 and $420.
