How much oil does a 1995 Camaro 3.4 take?
In brief, the 1995 Camaro with the 3.4-liter V6 uses about 4.5 quarts of engine oil when performing an oil change with a new filter. This equates to approximately 4.3 liters.
This article explains the official capacity figures, recommended oil grade, and a practical, step-by-step guide to a proper oil change for this classic GM muscle car.
Oil capacity for the 1995 Camaro 3.4L V6
Key capacity figures
- Oil capacity with filter: 4.5 quarts (approximately 4.3 liters).
- Oil capacity without filter: about 4.0 quarts (approximately 3.8 liters).
- Recommended oil grade: typically 5W-30 (API SM/SN or better) for most climates; always confirm with the owner's manual or a trusted GM service document.
These figures help you plan your oil change and ensure you fill to the correct level after changing the filter and draining the old oil.
Oil change procedure for the 1995 Camaro 3.4L V6
Below is a concise, step-by-step guide to performing an oil change on this model year and engine.
- Warm the engine by running it for a few minutes, then park on level ground and engage the parking brake.
- Lift the front of the car safely and support it with jack stands; keep the car stable before crawling underneath.
- Place a drain pan under the oil pan, remove the drain plug, and allow the old oil to drain completely.
- Remove the oil filter, inspect it, and install a new filter; lightly coat the gasket on the new filter with fresh oil.
- Reinstall the drain plug securely after drainage, then pour in the correct amount of oil—start with 4.5 quarts (with filter) as a typical target for this engine.
- Install the fill cap, start the engine and run for about 60 seconds to circulate oil, then turn off and check for leaks.
- Check the oil level with the dipstick and add oil in small increments until the level sits between the low and full marks; recheck after a few minutes for settling.
Note: Depending on the exact engine configuration or filter size, the total oil you need may vary by a small amount. If in doubt, consult the service manual or a qualified mechanic.
Oil grade and climate notes
The typical recommendation for this engine is a conventional detergent oil in the 5W-30 range for a broad range of temperatures. In very hot climates or severe service, some technicians opt for 10W-30, but always verify with the manual or a professional. Use an API-approved oil and replace the gasket on the drain plug if it shows wear.
Summary
For a 1995 Camaro with the 3.4L V6, plan to use about 4.5 quarts of engine oil when changing the oil with a new filter (roughly 4.3 liters). Always confirm exact specifications in your owner's manual, and adjust slightly if your vehicle has a different oil filter or if you perform a drain-and-fill without a filter replacement.
