How much oil does a 1997 Acura CL 2.2 take?
Approximately 4.5 quarts of engine oil are needed for a full change with a new oil filter (about 4.3 liters).
The 1997 Acura CL 2.2 uses a 2.2-liter inline-four engine. When performing an oil change, the conventional reference capacity includes the oil that fills after a fresh filter is installed. Actual capacity can vary slightly based on filter type and any aftermarket parts, so it’s wise to verify with the vehicle’s manual or a professional mechanic if you’ve made modifications.
Oil capacity and where it comes from
Factory capacity figures (with filter) are as follows:
- With filter: 4.5 quarts (4.3 liters)
- Without filter: 4.0 quarts (3.8 liters)
After pouring in new oil, run the engine briefly, then turn it off and wait a few minutes before re-checking the level on the dipstick. Top off as needed to reach the full mark without overfilling.
Recommended oil type and change guidance
To maintain optimal performance and engine longevity, use the oil viscosity recommended for this era Acura/Honda engine. The typical guidance for most climates is 5W-30 oil, though some hot climates or specific conditions may call for adjustments per the owner's manual. Always confirm the exact specification for your vehicle.
- Use 5W-30 for most regions; consult the owner's manual for alternate recommendations if you live in extreme temperatures.
- Check the oil level with the dipstick after the engine has rested for several minutes.
- Replace the oil filter with every oil change and reinstall a new drain plug washer if your vehicle requires one.
After completing the service, reset any maintenance reminder if your car is equipped with one.
Summary
The 1997 Acura CL 2.2 typically holds about 4.5 quarts of engine oil with a new filter (approximately 4.0 quarts without one). Use a compatible viscosity—commonly 5W-30—for most driving conditions, and always verify the exact specification in the owner’s manual for your specific vehicle configuration. When in doubt, consult a qualified technician to confirm capacity and procedures before an oil change.
