How much oil does a 1998 Acura Rl take?
The 1998 Acura RL’s 3.5-liter V6 typically takes about 5.5 quarts of engine oil with a filter.
Understanding this figure helps owners plan oil changes, ensure proper lubrication, and avoid overfilling. Below is a detailed breakdown based on common factory specifications and routine maintenance practices for this model year.
Capacity and engine details
The RL from this era relies on a 3.5-liter V6 designed for reliable everyday performance. The officially quoted capacity for a standard oil change is about five and a half quarts with the filter installed. Actual fill can vary slightly depending on whether you replace the filter, perform a full drain, or account for residual oil in the engine and filter. Always verify with the dipstick and consult the owner’s manual for exact guidance.
When performing maintenance, you should expect that a full drain and filter replacement uses roughly the full 5.5-quart capacity, while a drain-and-fill without a filter change may require somewhat less. Use the dipstick to confirm the correct level after adding oil.
Before moving to the practical guidance below, note these capacity figures are intended as a baseline to help you plan your service and avoid under- or overfilling.
Capacity details in brief:
- With a standard oil change and new filter: approximately 5.5 quarts (about 5.2 liters).
- Without replacing the filter (drain only, then refill): roughly 5.0 quarts, depending on how much oil remains in the engine and filter.
In practice, always verify with the dipstick after adding oil to reach the correct level. These figures are approximate and can vary by factory tolerances and oil filter type.
Oil type and viscosity recommendations
Choosing the right oil grade and formulation helps protect the engine and maintain performance across seasons. For the 1998 RL, the typical recommendation is to use 5W-30 motor oil as the standard grade. Both conventional and synthetic oils are acceptable, with synthetic offering potential benefits in temperature stability and longer intervals if you follow manufacturer guidelines. Always confirm with the owner’s manual or an Acura service bulletin for your specific vehicle.
Below are the common guidelines to consider when selecting oil for this model year:
- Viscosity: 5W-30 is the standard recommendation for normal driving conditions.
- Oil type: Either conventional or synthetic oil can be used; synthetic may be preferred for longevity and performance in extreme temperatures.
Consult the owner’s manual for the exact API service category and any Acura-specific specifications relevant to your VIN and regional climate. These choices help ensure optimal lubrication and engine longevity.
Maintenance tips: checking and topping off oil
Properly checking and maintaining oil levels is essential to engine health. Here are routine steps to follow when you service a 1998 RL:
- Park on level ground and wait a few minutes after turning off the engine to allow oil to settle.
- Open the hood and locate the oil dipstick; wipe it clean, reinsert fully, then pull it out to check the level against the markings.
- If the level is low, add oil in small increments (about a quarter to a half-quart at a time), recheck with the dipstick, and stop at the full mark.
- Use the recommended viscosity (typically 5W-30 for this model) and a suitable grade based on climate if you have winter or extreme heat conditions.
- Recheck for leaks and ensure the oil cap is securely tightened after topping up.
Regular monitoring helps prevent engine wear and ensures you stay within the correct oil level between changes. If you’re unsure about the right amount or type, refer to the owner’s manual or contact an Acura service professional.
Summary
For the 1998 Acura RL, plan on roughly 5.5 quarts of engine oil with a filter for a full oil change. Use 5W-30 as the standard viscosity, with the option of synthetic oil for improved performance and longevity. Always confirm exact specifications with the owner’s manual and verify levels with the dipstick after adding oil.
How much oil does a 1998 LS400 take?
Oil Grade: SL
| Viscosity: | 5W-30 (All TEMPS) - SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 5.9 quarts (with filter). After refill check oil level. |
| Torque: | 14 ft/lbs (Oil Drain Plug) |
How much oil does an Acura Rl take?
4.5 quarts (with filter). After refill check oil level. Capacity: 4.2 quarts.
What kind of oil does a 1998 Acura RL take?
The recommended oil for a 1998 Acura RL is SAE 5W-30 for all temperatures, which is the preferred viscosity. The engine oil capacity is 4.5 quarts without a filter change and 4.9 quarts with a filter change.
Specifications
- Viscosity: SAE 5W-30 (preferred for all temperatures)
- Capacity:
- 4.5 quarts (without filter)
- 4.9 quarts (with filter)
- Torque for drain plug: 33 ft/lbs
How much oil does a 3.8 L V6 engine take?
A 3.8L V6 engine typically takes between 4.5 and 6 quarts of oil, depending on the specific vehicle and year. For example, a 1994-2004 Ford Mustang with a 3.8L V6 needs about 5 quarts, while a 2007-2011 Jeep Wrangler with a 3.8L V6 takes about 6 quarts. Always check your vehicle's owner's manual or consult a reliable source, like an oil capacity chart, to confirm the exact amount for your specific model, and always check the oil level with the dipstick after refilling.
Here are some examples of oil capacities for different vehicles with a 3.8L V6 engine:
- Ford Mustang (1994-2004): ~5 quarts
- Jeep Wrangler (2007-2011): ~6 quarts
- Pontiac Grand Prix (2008, 3800 V6): ~4.5 quarts
- Buick LeSabre (2000): ~7.4 quarts
