How much oil does a 2.0 L TDI take?
The typical oil capacity for a 2.0-liter TDI engine is about 4.5 liters when performing a full change with a new filter. If the filter isn’t replaced, the amount is usually closer to 4.0–4.3 liters. Exact figures vary by engine code and generation, so consult your manual for the precise specification.
Engine variants and typical capacities
The following figures are approximate guidelines and can differ by model year, engine code, and oil filter size. Use them as a baseline, then confirm with the official service documentation for your vehicle.
- PD 2.0 TDI (older, non-common-rail): typically about 4.3–4.5 liters with a new filter (≈4.5–4.8 quarts).
- CR 2.0 TDI (common-rail, many VW Group models, ~2009–2015): typically around 4.3–4.5 liters with filter (≈4.5–4.8 quarts).
- EA189 2.0 TDI (widely used in 2010s models): commonly about 4.3–4.5 liters with filter (≈4.5–4.8 quarts).
- EA288 2.0 TDI (modern generation, newer platforms): typically around 4.2–4.5 liters with filter (≈4.4–4.8 quarts).
Note: The difference between capacities with and without replacing the oil filter can be about 0.2–0.4 liters, so it matters for your fill amount if you’re not changing the filter.
Practical tips for filling and checking oil
To ensure a correct fill, follow these steps: use the recommended oil grade (often 5W-40 or 5W-30 for diesels), start with a little less than the target amount, let the oil settle, then recheck with the dipstick. Add small increments until the level sits between the minimum and maximum marks. If you’re unsure, err on the side of slightly under the max mark to avoid overfilling.
When in doubt, verify the exact capacity for your vehicle by consulting the owner’s manual or the service documentation tied to your engine code. Some models require a specific oil filter that can slightly alter capacity, so the precise figure can vary even within the same family of engines.
How to confirm the exact figure for your car
Because engine codes and design changes influence capacity, always check the official specification for your exact vehicle. Look up your engine code (often printed on the engine block or in the fuel economy sticker) and cross-reference it with the maintenance manual or factory service bulletins. If you’re performing a DIY oil change, note the filter model and any accessories that might affect the total capacity.
In practice, a safe approach is to start with about 4.5 liters of oil, run the engine briefly, turn it off, wait a few minutes for oil to settle, then check the dipstick and top up in small steps to stay within the indicated range.
Summary
For most 2.0 L TDI engines, the standard oil change capacity with a new filter is around 4.5 liters, with a typical range of 4.2–4.8 liters depending on the exact engine code and whether the filter is replaced. Always verify the exact specification for your vehicle and follow proper filling and checking procedures to maintain engine health.
What oil does a VW 2.0 TDI take?
This Engine Oil fits the following vehicles
| Model | Golf 2.0 GT TDi MK5 (Typ1K1) (2003-2009) |
|---|---|
| Description | Castrol EDGE 5W-30 LL |
| Engine Code | BMN, CFGB, CBBB, BDK, CBDC, CBAB, CFFB, CJAA, CBDB, CFHC, BMM, BKD, AZV, CBDB, BKD |
| BHP | 168, 75, 108, 138 |
| Fitment Detail | Engine |
How much oil does a VW Passat 2.0 TDI take?
The engine oil capacity for a VW Passat 2.0 TDI varies by model year, but it is typically around 4.5 to 5.8 quarts (4.3 to 5.5 liters) when changing the oil and filter. For example, a 2015 model might require 5.8 quarts (5.5 liters), while earlier models like the 2013 could use 4.5 quarts (4.3 liters). Always check your specific owner's manual or a reliable source for your exact model year to ensure the correct capacity and oil specification (like the VW 507 00 standard).
- 2015 Passat TDI: ~5.8 quarts (5.5 liters)
- 2013 Passat TDI: ~4.5 quarts (4.3 liters)
- 2012-2014 (CKRA engine): 4.5 quarts (4.3 liters) is a common figure, though some 2015 models may have a different requirement.
Important considerations:
- Check your owner's manual: The capacity can vary between model years, so always consult your owner's manual for the most accurate information.
- Use correct oil specification: It is crucial to use oil that meets the required Volkswagen specification, such as the VW 507 00 standard, for your vehicle to ensure proper engine function and protection.
- Use the dipstick: It is best to add the specified amount, start the engine, then turn it off and wait a few minutes before checking the dipstick to top off if needed.
How much oil does a 2011 VW Golf 2.0 TDI take?
Engine Oil
Capacity: 4.5 quarts (with filter).
How many quarts of oil does a 2.0 TDI take?
Fill the engine with 4.3 liters or 4.5 quarts of engine oil that carries the VW 507 00 oil specification.
