How much oil does a 2000 NSX take?
A 2000 NSX typically takes about 5 quarts (4.7 liters) of engine oil for a standard oil change with a new filter.
In the 2000 NSX, which uses the 3.2-liter V6 (engine code C32B), the official capacity for a complete oil change including the filter is around 5.0 quarts (4.7 liters). Actual amounts can vary slightly depending on the oil filter used and how thoroughly the old oil drains. Always verify the level with the dipstick after you fill.
Oil capacity at a glance
Below is a quick reference you can use during a routine oil change to ensure you have the right amount of oil.
- 5.0 quarts (approximately 4.7 liters) of engine oil, including a new oil filter
Note: The exact amount can vary by filter choice and production year; consult the owner's manual or service manual for the precise specification for your car.
Oil quality and maintenance tips
Choosing the right oil viscosity and type supports the NSX's performance and longevity. The following guidelines reflect common practice among NSX owners; refer to the owner’s manual for the official specification.
Before selecting oil, consider climate, driving style, and any warranty considerations.
- Viscosity: 5W-30 is a common default; 10W-30 can be used in hotter climates or older engines, as appropriate.
- Oil type: Use a high-quality engine oil that meets API/SN or later requirements; many owners prefer full synthetic for protection and efficient draining intervals.
At minimum, replace the oil filter with every drain, and recheck the oil level after filling. Follow the recommended change interval in the owner's manual, typically every 5,000–7,500 miles depending on driving conditions and oil type.
Summary
The 2000 NSX normally requires about 5 quarts (4.7 liters) of oil for a complete change, including the filter. Always verify the level with the dipstick after adding oil and consult the owner's manual for the exact viscosity and change interval that applies to your climate and driving conditions.
How many quarts of oil does a 1.8 L engine take?
A 1.8-liter engine typically takes between 3.5 and 4.5 quarts (about 3.3 to 4.3 liters) of oil, but this can vary significantly by make and model. The exact amount depends on the specific vehicle, and you should always check the owner's manual for the precise capacity, including whether a filter change requires a different amount.
- Check your owner's manual: This is the most reliable source for the exact amount of oil needed for your specific car.
- Consult online resources: Use your car's year, make, and model to search for specific oil capacities on automotive websites or forums.
- Add and check: It's best to start by adding about 4 quarts (or 3.5 liters) and then check the dipstick to ensure it's at the correct level. You can add more oil gradually until the dipstick indicates it's full, but do not overfill.
- Factor in the filter: If you are changing the oil filter at the same time, you will likely need the higher end of the capacity range.
- Safety note: Always wait a few minutes after running the engine for the oil to settle before checking the dipstick, and never overfill the engine with oil.
What kind of oil does a Honda NSX take?
An oil with a viscosity of 10W-30 is preferred for improved fuel economy and year-round protection in your NSX. You may use a 5W-30 oil if the climate in your area is within the temperature range shown on the chart. A fuel-efficient oil is recommended for your NSX.
PDF
How much oil does a 3.8 L V6 take?
A 3.8L V6 engine typically takes between 4.5 and 6 quarts of oil, depending on the specific vehicle and year. For example, a 1994-2004 Ford Mustang with a 3.8L V6 needs about 5 quarts, while a 2007-2011 Jeep Wrangler with a 3.8L V6 takes about 6 quarts. Always check your vehicle's owner's manual or consult a reliable source, like an oil capacity chart, to confirm the exact amount for your specific model, and always check the oil level with the dipstick after refilling.
Here are some examples of oil capacities for different vehicles with a 3.8L V6 engine:
- Ford Mustang (1994-2004): ~5 quarts
- Jeep Wrangler (2007-2011): ~6 quarts
- Pontiac Grand Prix (2008, 3800 V6): ~4.5 quarts
- Buick LeSabre (2000): ~7.4 quarts
How many quarts of oil does a 3.3 L V6 take?
6.0 qt
Materials
| Variant | Including the Oil Filter |
|---|---|
| All. | 6.0 qt (5.7 L) |
