How much oil does a 2008 4.6 take?
The 2008 4.6-liter engine typically requires 5 to 6 quarts of oil for a full oil change. The exact oil capacity can vary slightly depending on the specific vehicle model and other factors, but this is the general range for most 2008 4.6-liter engines.
Detailed Explanation
The 2008 4.6-liter engine is a V8 engine commonly found in various Ford and Lincoln vehicles, such as the Ford F-150, Ford Expedition, and Lincoln Navigator. The oil capacity for this engine is determined by several factors, including the engine design, oil filter size, and the specific vehicle model.
According to the information gathered from various automotive sources, the typical oil capacity for a 2008 4.6-liter engine is between 5 and 6 quarts. This range accounts for potential variations in the engine design and vehicle model. It's important to always refer to the owner's manual or the vehicle's information placard to determine the exact oil capacity for a specific 2008 4.6-liter engine.
Oil Change Procedure
When performing an oil change on a 2008 4.6-liter engine, it's essential to follow the manufacturer's recommended oil type and change interval. The owner's manual will provide the specific details, but generally, the following steps should be followed:
- Park the vehicle on a level surface and apply the parking brake.
- Locate the oil drain plug, typically located at the bottom of the oil pan, and place a drain pan underneath.
- Unscrew the drain plug and allow the old oil to drain completely.
- Once the oil has drained, replace the drain plug and tighten it securely.
- Locate the oil filter, typically accessible from the top or side of the engine, and remove it using an oil filter wrench.
- Apply a thin coat of new oil to the gasket of the new oil filter and screw it on until it's snug.
- Unscrew the oil fill cap and pour in the recommended amount of new oil, typically between 5 and 6 quarts.
- Replace the oil fill cap and start the engine, checking for any leaks.
- Allow the engine to run for a few minutes, then check the oil level using the dipstick and add more oil if necessary.
It's important to dispose of the old oil and filter properly, as they can be harmful to the environment if not handled correctly.
How many quarts of oil does a 4.6 Northstar engine take?
All 2000-2011 Cadillac Northstar V8s use 5w30 Engine oil. Capacity on all front wheel drive cars is 7.5 quarts, or 7.1 liters including oil filter. The only engine oil supplement I will recommend or allow the use of under engine warranty, is GM "Engine Oil Supplement" available through GM dealers.
How much oil does a 4.6 Rover V8 take?
| Engine Oil Chart For Land Rovers | ||
|---|---|---|
| Model | Year | Capacity Litres |
| Discovery 2 - 4.0/4.6 V8 petrol without oil cooler | 1998-2004 | 5.00 |
| Discovery 2 - 4.0/4.6 V8 petrol with oil cooler | 1998-2004 | 6.30 |
| Discovery 3 - 2.7 TDV6 | 2005-2009 | 5.70 |
What oil does a 2008 Mustang 4.6 take?
AMSOIL OE 5W-20 100% Synthetic Motor Oil.
How much oil does a 4.6 L V8 take?
6 quarts
Capacity: 6 quarts (with filter). When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level.
How many quarts of oil does a 4.6 GT take?
Oil Grade: SEO15
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 6 quarts (with filter). After refill check oil level. |
| Torque: | 10 ft/lbs (Oil Drain Plug) |
Is 4.6 liter V8 good?
The Ford 4.6 engine features a V8 configuration that displaces 4.6 liters and delivers up to 302 horsepower. It's a considerably powerful engine and is commonly found in the Ford Mustang, Expedition, Explorer, and F-150. Ford 4.6 engine blends affordability, power, and reliability for enhanced performance.
How much horsepower does a 2008 4.6 V8 have?
Acceleration and Power
Three engines are available for the Ford F-150 -- a 4.2-liter V6 that creates 202 horsepower and 260 pound-feet of torque, a 4.6-liter V8 that creates 248 horsepower and 294 pound-feet of torque and a 5.4-liter V8 that creates 300 horsepower and 365 pound-feet of torque.
How much oil does a 2008 DTS 4.6 take?
Oil Grade: SEO22
| Viscosity: | 5W-30 (All TEMPS) |
|---|---|
| Capacity: | 7.5 quarts (with filter). After refill check oil level. |
| Torque: | 15 ft/lbs (Oil Drain Plug) |
How much oil does a 2008 Ford 4.6 take?
6 quarts
Oil Grade: SEO15
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 6 quarts (with filter). When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level. Top off to proper level as needed. |
| Torque: | 10 ft/lbs (Oil Drain Plug) |
How much horsepower does a 4.6 L Rover V8 have?
In 1995, Land Rover enlarged the Rover V8 to 4,552 cc (4.6 L; 277.8 cu in). The bore remained the same size as the previous 4.0 at 94 mm (3.7 in), but the engine was stroked by 10.9 mm (0.43 in) giving 82 mm (3.23 in) in total. Output was 225 hp (168 kW; 228 PS) and 280 lb⋅ft (380 N⋅m).
