How much oil does a 2009 Dodge Dakota 4.7 take?
About 5 quarts (4.7 liters) of engine oil, with a new filter, for a standard full oil change on the 2009 Dakota's 4.7L V8.
In the 2009 Dodge Dakota, the 4.7-liter PowerTech V8 was the common engine, and the official oil-capacity specification for this setup is typically five quarts with the filter installed. When performing an oil change, drain the old oil, replace the filter, and refill to roughly five quarts, then recheck the level with the dipstick once the oil has settled. Always verify the exact specification for your specific truck by consulting the owner's manual or the under-hood label, as production tweaks or regional requirements can alter the precise figure.
Oil capacity and maintenance considerations
The capacity figure applies to the 4.7L V8 commonly found in the 2009 Dakota. If your truck has a different engine, such as a 3.7L V6, the capacity may differ slightly, so the best source is the owner’s manual and the engine’s oil-capacity label under the hood.
- Engine: 4.7L V8 (PowerTech)
- Oil capacity with filter: 5 quarts (4.7 L)
- Recommended oil viscosity: typically 5W-20 or 5W-30 depending on climate and manual guidance
Key facts at a glance:
When performing an oil change, ensure you replace the filter and use the correct oil grade, then recheck the level with the dipstick after running the engine and allowing the oil to settle.
Summary
The 2009 Dodge Dakota with the 4.7L V8 generally requires about 5 quarts (4.7 liters) of engine oil for a full change with a new filter. Always confirm the exact amount and viscosity from your owner's manual or under-hood label, as variations can occur by factory, climate, or vehicle configuration.
