How much oil does a 2010 Dodge Avenger 3.5 take?
The 2010 Dodge Avenger 3.5 takes 5 quarts of oil. This is the standard oil capacity for this vehicle model and engine size.
Detailed Answer
The 2010 Dodge Avenger is a midsize sedan that was produced by Chrysler. The 3.5-liter V6 engine found in some Avenger models requires 5 quarts of oil for a full oil change. This is the standard oil capacity specified by the manufacturer for this particular engine configuration.
To maintain the Avenger 3.5's engine health and performance, it's important to use the correct oil type and change it at the recommended intervals. The owner's manual will specify the recommended oil grade, such as 5W-20 or 5W-30, as well as the oil change schedule, which is typically every 3,000 to 5,000 miles.
Oil Change Procedure
- Park the vehicle on a level surface and apply the parking brake.
- Locate the oil drain plug, usually on the bottom of the oil pan, and place a drain pan underneath.
- Unscrew the drain plug and allow the old oil to fully drain out.
- Once drained, replace the drain plug and tighten it securely.
- Locate the oil filter, typically accessible from the top of the engine, and remove it using an oil filter wrench.
- Apply a thin coat of new oil to the gasket of the new oil filter, then screw it on until secure.
- Unscrew the oil fill cap and pour in 5 quarts of the recommended oil grade.
- Replace the oil fill cap and start the engine to circulate the new oil.
- Check the oil level using the dipstick and add more oil if necessary to reach the full mark.
Following the proper oil change procedure and using the correct oil quantity will help ensure the 2010 Dodge Avenger 3.5 engine runs smoothly and efficiently.
