How much oil does a 2013 Mondeo 2.0 TDCi take?
The 2013 Mondeo with a 2.0 TDCi diesel typically requires about 5.0 liters of engine oil for a full change, including the replacement filter. The exact amount can vary slightly depending on whether the oil filter is replaced and the specific engine variant.
Context: the Mondeo’s engine and service basics
The 2013 Mondeo uses a 2.0-liter Duratorq TDCi diesel engine. When performing maintenance, technicians commonly follow Ford’s recommendation for synthetic oil of appropriate viscosity (often 5W-30 or 5W-40, depending on climate and market) and replace the oil filter. The stated capacity assumes a complete drain and proper refilling with the filter change.
Official capacity and practical figures
Key capacity figures and what they include are listed below. These figures help technicians gauge how much oil to add during an oil change.
- Oil capacity with the oil filter installed: approximately 5.0 liters
- Oil capacity without the filter: roughly 4.3–4.5 liters
In practice, many DIY enthusiasts start with about 4.5–5.0 liters, run the engine briefly, then shut it off, wait for the oil to settle, and top up in small increments until the dipstick reads within the correct range.
Practical tips for accuracy
Use a synthetic oil that meets Ford specifications for the 2.0 TDCi and install a fresh oil filter. After adding the initial amount, run the engine for about a minute, switch off, wait a few minutes for the oil to settle, then recheck the level and add small amounts as needed to reach the full mark on the dipstick.
Why capacity can vary and how to confirm
Variations in capacity can stem from engine variant, presence of a diesel particulate filter (DPF), and the exact drain procedure. For the most precise figure, consult the owner’s manual or a Ford service bulletin for your specific 2013 Mondeo 2.0 TDCi variant, or check with a dealer if you’re unsure.
Summary
The typical oil capacity for a 2013 Ford Mondeo 2.0 TDCi is about 5.0 liters with the filter included. Expect roughly 4.3–4.5 liters if the filter is not replaced. Always verify with the dipstick and follow Ford’s oil grade recommendations and service instructions to ensure proper lubrication.
