How much oil does a 2014 Chevy Sonic 1.4 take?
Approximately 4.5 quarts (about 4.3 liters) of engine oil are needed for a full oil change on the 2014 Chevy Sonic with the 1.4-liter engine, including a new filter.
What you should know about the Sonic 1.4 oil capacity
The Sonic lineup for 2014 offered a 1.4-liter turbo engine (alongside a 1.8-liter option in some trims). The capacity figure below specifically reflects a typical 1.4L engine oil change with filter replacement. If you drain only the sump and do not replace the filter, the amount you refill may be slightly lower.
- Oil capacity with a new filter: about 4.5 quarts (4.3 liters).
- Oil capacity without replacing the filter: about 4.0 quarts (3.8 liters).
These figures are approximate and can vary slightly by exact vehicle configuration, regional specs, and filter size. Always confirm with your owner’s manual or a GM service advisor for your specific car.
Oil type and change guidance
For most 2014 Sonic 1.4 engines, manufacturers typically recommend a Dexos1 Gen 2 approved oil, commonly 5W-30 for typical climates. In some regions or under certain conditions, a 0W-30 or 5W-20 may be acceptable if specified in the manual. Always use the grade and specification listed in your owner’s manual and check the dipstick after filling to ensure the oil level is at the “Full” mark.
DIY tips: checking and refilling oil
To ensure you add the correct amount when topping up between changes, follow these steps:
- Park on level ground and run the engine briefly to warm the oil, then turn it off and wait a few minutes.
- Remove the dipstick, wipe it clean, reinsert fully, and pull it out to check the current level.
- If the level is below the “Full” mark, add small amounts of oil at a time, rechecking with the dipstick until you reach the correct level.
When performing an oil change, ensure you replace both the oil and the filter, and dispose of the old oil properly. After a new fill, recheck the level again once the engine has run and settled.
Summary
The 2014 Chevy Sonic with the 1.4-liter engine generally takes about 4.5 quarts (4.3 liters) of engine oil when you replace the filter. If you don’t replace the filter, the total needed is closer to 4.0 quarts (3.8 liters). Use Dexos1 Gen 2 approved oil, typically 5W-30, and consult your owner's manual for the exact specification and intervals specific to your vehicle.
How many quarts of oil does a 2014 Chevy Sonic hold?
The 2014 Chevy Sonic oil capacity is 4.8 quarts for the 1.8L engine and 4.2 quarts for the 1.4L turbo engine, both with a new oil filter. It's important to check your owner's manual or use a dipstick to confirm the correct level after adding oil, as the 1.4L engine capacity can vary slightly.
1.8L engine
- Oil capacity: 4.8 quarts (with filter).
- Recommended oil: 5W-30.
1.4L Turbo engine
- Oil capacity: 4.2 quarts (with filter).
- Recommended oil: 5W-30.
Important considerations
- Check the dipstick: Always use the dipstick to verify the oil level after refilling, as the exact capacity can vary slightly depending on the vehicle.
- Use the correct oil: Ensure you are using the recommended oil viscosity for your engine and climate.
How much oil does a 1.4 Chevy Sonic take?
Compatibility
| Year | Make | Notes |
|---|---|---|
| 2020 | Chevrolet | 4.25 Quart (qt) Capacity |
| 2020 | Chevrolet | 4.25 Quart (qt) Capacity |
| 2019 | Chevrolet | 4.25 Quart (qt) Capacity |
| 2019 | Chevrolet | 4.25 Quart (qt) Capacity |
How many quarts of oil does a 2014 Chevy Cruze 1.4 L take?
The 2014 Chevy Cruze 1.4L engine has an oil capacity of 4.2 quarts (or 4.0 liters) with a filter change. It is recommended to use a 5W-30 full synthetic motor oil and to refill gradually, checking the dipstick to ensure the correct level.
- Capacity: 4.2 quarts with filter
- Oil type: SAE 5W-30 full synthetic is recommended
- Refill tip: Add oil gradually and check the dipstick to avoid overfilling
How much oil does a 1.4 Chevy take?
The oil capacity for a Chevy 1.4L engine is approximately 4.2 to 4.25 quarts with a filter change, though it's best to add slightly less initially and top off after checking the dipstick. For an initial fill during an oil change, start with about 4 quarts, run the engine, and then check the level with the dipstick to ensure it's within the correct range.
- Approximate capacity: 4.2 quarts (4.0 L) is a common capacity with a filter change. Some sources list it as high as 4.25 quarts.
- Recommendation: Add about 4 quarts at first.
- Final check: After adding 4 quarts, start the engine for about 30 seconds, let it sit for a few minutes, and then check the dipstick to see if it needs more oil to reach the "full" mark.
- Oil type: The recommended oil is typically 5W-30, but check your owner's manual for specific recommendations.
