How much oil does a 2015 Ford Transit 150 diesel take?
The 2015 Ford Transit 150 diesel (3.2L Power Stroke I5) requires about 11.6 quarts of engine oil, which is roughly 11.0 liters, for a full oil change with a new filter. Exact capacity can vary slightly by market and filter type, so always confirm with your owner’s manual or Ford service data for your VIN.
Oil capacity specifics for the 2015 Transit 150 diesel
Below is the core capacity figure most commonly cited for the 3.2L Power Stroke diesel used in the Transit 150. The official specification is given here to guide maintenance and top-ups.
Note: The following capacity applies to a standard oil change that includes replacing the filter. If you drain only and do not replace the filter, you may need a bit less oil; always verify with the vehicle’s service data.
- 3.2L Power Stroke I5 diesel (2015 Transit 150) — approximately 11.6 quarts (11.0 liters) of engine oil when replacing the filter.
In practice, some workshop manuals and third-party listings may round or state a nearby figure (often up to about 12 quarts). For precise maintenance, rely on the Ford service data for your specific VIN and regional spec.
Tips for an accurate oil fill and level check
To ensure you fill to the correct level and avoid under- or overfilling, follow these steps and verify with the dipstick after startup and a brief idle period.
- Warm the engine to normal operating temperature so the oil is fully circulated.
- Park on a level surface and set the parking brake.
- With the engine off, place an oil drain pan beneath the sump and remove the drain plug to allow all old oil to drain completely.
- Replace the drain plug gasket if needed and install a new oil filter; pre-lube the filter gasket with a touch of new oil.
- Pour in the recommended amount of oil via a funnel, then replace the oil filler cap.
- Wait a few minutes for oil to settle, then check the dipstick and add oil in small increments until the level sits between the min and max marks.
Following these steps helps ensure you reach the correct level and maintain proper engine lubrication.
Why the capacity matters and how often to change it
Knowing the correct oil capacity helps avoid underfilling, which can cause inadequate lubrication, and overfilling, which can create excessive pressure or foaming. For the 2015 Transit 150 with the 3.2L diesel, standard maintenance intervals typically recommend an oil change every 7,500–10,000 miles (12,000–16,000 km) under normal conditions, or sooner in severe service. Always use the recommended oil grade and consult Ford’s service schedule for your region.
Summary
For the 2015 Ford Transit 150 diesel, plan to use about 11.6 quarts (11.0 liters) of engine oil when performing a full oil change with a new filter. Verify the exact capacity for your vehicle using the owner’s manual or Ford service data, as regional specifications can vary. Accurate oil fills support engine longevity and performance.
