How much oil does a 2016 e350 take?
The 2016 Mercedes-Benz E 350 typically requires about 7.5 quarts (7.1 liters) of engine oil when performing a standard oil change that includes replacing the filter. Exact capacity can vary slightly by market and engine variant, so check your owner's manual or a Mercedes service manual for your specific car.
In deeper terms, the E 350 from this year uses a 3.5-liter V6 engine. While the general fill during a routine oil change sits around 7.5 quarts, some configurations or regions may cite a slightly wider range. Using the correct synthetic oil that meets Mercedes-Benz specifications is also important for performance and longevity.
Engine and oil type for the 2016 E 350
The 2016 E 350 is equipped with a 3.5-liter V6 engine. Mercedes-Benz typically recommends a fully synthetic motor oil that meets MB 229.5 specifications, commonly in viscosities such as 0W-40 or 5W-40 depending on climate and model year. Always verify the exact specification for your vehicle in the owner's manual or through a Mercedes-Benz dealer.
Official capacity and how it’s measured
Capacity figures can differ slightly by market, production date, and whether the oil filter is replaced during a change. The following figures reflect typical fills for a standard oil change with a new filter on the 2016 E 350’s 3.5L V6:
- 7.5 quarts (7.1 liters) including the oil filter — the common starting point for a complete change.
- Up to about 8.0 quarts (7.6 liters) total capacity in some markets or configurations, if a full fill is required or if the engine starts with a higher oil level.
When performing an oil change, begin by adding roughly 7.5 quarts, then use the dipstick to check the level. Top off in small increments until the indicator shows the oil at the full mark. Do not exceed the recommended maximum.
Practical tips for the oil change
To help ensure a correct fill and optimal engine protection, consider these best practices during an oil change:
- Park on a level surface and allow the engine to cool for a few minutes before draining.
- Replace the oil filter with the proper MB-approved filter for the 3.5L V6.
- Use a synthetic oil that meets MB 229.5 specifications (commonly 0W-40 or 5W-40, depending on climate).
- Pour in about 7.5 quarts to start, then check the level with the dipstick and top up as needed.
- Ensure the drain plug, filter housing, and oil fill cap are properly resealed and that the oil is circulated before final level check.
For the most accurate guidance, consult the owner's manual or contact an authorized Mercedes-Benz service center. Individual vehicles can have slight variations based on production changes, country-specific requirements, and engine finishes.
Summary
The 2016 E 350 generally takes around 7.5 quarts of engine oil, including the filter, with a typical total capacity near 7.5–8.0 quarts. Use a synthetic oil that meets Mercedes-Benz MB 229.5 specifications and verify the exact capacity for your specific vehicle model and market. Always rely on the dipstick and official manuals to confirm the proper fill level after an oil change.
