How much oil does a 2017 Toyota iA take?
The 2017 Toyota iA, a compact sedan, requires 4.4 quarts (4.2 liters) of 0W-20 engine oil. This oil capacity is specified by the manufacturer and is the recommended amount to ensure proper lubrication and performance of the vehicle's engine.
Detailed Overview
The 2017 Toyota iA is a subcompact sedan that was produced as a result of a partnership between Toyota and Mazda. It was marketed as the Scion iA before the Scion brand was discontinued, and then rebranded as the Toyota iA.
The iA is powered by a 1.5-liter four-cylinder engine that produces 106 horsepower and 103 lb-ft of torque. This engine is designed to run on 0W-20 synthetic motor oil, which is the recommended oil type specified by Toyota for this vehicle.
Oil Change Procedure
To change the engine oil in a 2017 Toyota iA, you will need the following:
- 4.4 quarts (4.2 liters) of 0W-20 engine oil
- Oil filter
- Wrench or socket set
- Oil drain pan
The oil change process involves the following steps:
- Park the vehicle on a level surface and apply the parking brake.
- Locate the oil drain plug, usually located at the bottom of the oil pan, and place the drain pan underneath.
- Using the appropriate wrench or socket, loosen and remove the drain plug to allow the old oil to drain out.
- Once the oil has fully drained, replace the drain plug and tighten it securely.
- Locate the oil filter, typically accessible from the top of the engine, and use an oil filter wrench to remove it.
- Apply a thin coat of new oil to the gasket of the new oil filter, then screw it on by hand until secure.
- Unscrew the oil fill cap and pour in the 4.4 quarts (4.2 liters) of new 0W-20 engine oil.
- Replace the oil fill cap and start the engine, allowing it to run for a few minutes.
- Check the oil level using the dipstick and add more oil if necessary to reach the full mark.
Be sure to dispose of the old oil and filter properly, and keep a record of the oil change for future reference.
What kind of oil does a 2017 Toyota iA take?
Oil Grade: API*
| Viscosity: | 0W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.4 quarts (with filter). After refill check oil level. |
| Torque: | 26 ft/lbs (Oil Drain Plug) Replace drain plug gasket. Only use an OE drain plug. |
How much oil does a Toyota iA take?
2017 Toyota Yaris iA oil changes generally cost around $37 to $48 for 4.1 quarts of oil.
How many quarts of oil does a 4-cylinder Toyota take?
It depends on the size of your engine, however, for a Clermont Toyota Tacoma standard 2.7-liter four-cylinder engine or 3.5-liter V6 engine it's 6.2 quarts.
Does Toyota recommend full synthetic oil?
Toyota recommends Toyota Genuine SAE 0W-20 Full-Synthetic motor oil for new vehicles. Older models may require Toyota Genuine 5W-30 motor oil; consult with one of our service advisors or your vehicle manual to check if you are unsure.
How much oil does a 2.4 L 4-cylinder take?
4.5 quarts
4.5 quarts (with filter). After refill check oil level.
What kind of oil does a 2017 Toyota iM take?
0W-20 (All TEMPS) - 0W-20 is the best choice for good fuel economy and starting in cold weather. If 0W-20 is not available 5W-20 may be used. However, it must be replaced with 0W-20 at the next oil change.
How long will a 2017 Toyota Yaris iA last?
Nice ride, good gas mileage, good stereo. Toyota brand will go for 300, 000 miles if taken care of regularly. Yaris iA, is a sporty car.
How many quarts of oil does it take to fill up a Toyota?
Interactive Manual
| With filter | 4.9 qt. (4.6 L, 4.0 Imp. qt.) |
|---|---|
| Without filter | 4.5 qt. (4.3 L, 3.8 Imp. qt.) |
How much oil does a 2017 Toyota take?
4.4 quarts
A 2017 Toyota Corolla takes 4.4 quarts of oil. How much oil you should use depends considerably on the type of vehicle, engine size, and type of oil.
How much oil does a 2.4 L 4 cylinder Toyota take?
Interactive Manual
| Fluid capacity * | 2.5L 4-cylinder (A25A-FXS) engine | 4.6 qt. (4.4 L, 3.9 Imp. qt.) |
|---|---|---|
| 2.4L 4-cylinder (T24A-FTS) engine | 6.8 qt. (6.4 L, 5.6 Imp. qt.) | |
| Fluid type | Toyota Genuine ATF WS |
